OpenCores
URL https://opencores.org/ocsvn/neorv32/neorv32/trunk

Subversion Repositories neorv32

[/] [neorv32/] [trunk/] [docs/] [datasheet/] [soc_mtime.adoc] - Rev 71

Go to most recent revision | Compare with Previous | Blame | View Log

<<<
:sectnums:
==== Machine System Timer (MTIME)

[cols="<3,<3,<4"]
[frame="topbot",grid="none"]
|=======================
| Hardware source file(s): | neorv32_mtime.vhd | 
| Software driver file(s): | neorv32_mtime.c |
|                          | neorv32_mtime.h |
| Top entity port:         | `mtime_i` | System time input from external MTIME
|                          | `mtime_o` | System time output (64-bit) for SoC
| Configuration generics:  | _IO_MTIME_EN_ | implement MTIME when _true_
| CPU interrupts:          | `MTI` | machine timer interrupt (see <<_processor_interrupts>>)
|=======================

The MTIME module implements the memory-mapped MTIME machine timer from the official RISC-V
specifications. This module features a 64-bit system timer incrementing with the primary processor clock.
Besides accessing the MTIME register via memory operation the current system time can also be obtained using
the `time[h]` CSRs. Furthermore, the current system time is made available for processor-external
usage via the top's `mtime_o` signal.

The 64-bit system time can be accessed via the `TIME_LO` and `TIME_HI` memory-mapped registers (read/write) and also via
the CPU's `time[h]` CSRs (read-only). A 64-bit time compare register - accessible via the memory-mapped `TIMECMP_LO` and `TIMECMP_HI`
registers - is used to configure the CPU's MTI (machine timer interrupt). The interrupt is triggered
whenever `TIME` (high & low part) is greater than or equal to `TIMECMP` (high & low part).
The interrupt remain active (=pending) until `TIME` becomes less `TIMECMP` again (either by modifying `TIME` or `TIMECMP`).

[NOTE]
If the processor-internal **MTIME module is NOT implemented**, the top's `mtime_i` input signal is used to update the `time[h]` CSRs
and the `MTI` machine timer CPU interrupt (`MTI`) is directly connected to the top's `mtime_irq_i` input. The `mtime_o` signal
is hardwired to zero in this case.


.MTIME register map (`struct NEORV32_MTIME`)
[cols="<3,<3,^1,^1,<6"]
[options="header",grid="all"]
|=======================
| Address      | Name [C]      | Bits | R/W | Function
| `0xffffff90` | `NEORV32_MTIME.TIME_LO`    | 31:0 | r/w | machine system time, low word
| `0xffffff94` | `NEORV32_MTIME.TIME_HI`    | 31:0 | r/w | machine system time, high word
| `0xffffff98` | `NEORV32_MTIME.TIMECMP_LO` | 31:0 | r/w | time compare, low word
| `0xffffff9c` | `NEORV32_MTIME.TIMECMP_HI` | 31:0 | r/w | time compare, high word
|=======================

Go to most recent revision | Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.