URL
https://opencores.org/ocsvn/neorv32/neorv32/trunk
Subversion Repositories neorv32
[/] [neorv32/] [trunk/] [rtl/] [core/] [neorv32_xirq.vhd] - Rev 72
Go to most recent revision | Compare with Previous | Blame | View Log
-- ################################################################################################# -- # << NEORV32 - External Interrupt Controller (XIRQ) >> # -- # ********************************************************************************************* # -- # Simple interrupt controller for platform (processor-external) interrupts. Up to 32 channels # -- # are supported that get (optionally) prioritized into a single CPU interrupt. # -- # # -- # The actual trigger configuration has to be done BEFORE synthesis using the XIRQ_TRIGGER_TYPE # -- # and XIRQ_TRIGGER_POLARITY generics. These allow to configure channel-independent low-level, # -- # high-level, falling-edge and rising-edge triggers. # -- # ********************************************************************************************* # -- # BSD 3-Clause License # -- # # -- # Copyright (c) 2021, Stephan Nolting. All rights reserved. # -- # # -- # Redistribution and use in source and binary forms, with or without modification, are # -- # permitted provided that the following conditions are met: # -- # # -- # 1. Redistributions of source code must retain the above copyright notice, this list of # -- # conditions and the following disclaimer. # -- # # -- # 2. Redistributions in binary form must reproduce the above copyright notice, this list of # -- # conditions and the following disclaimer in the documentation and/or other materials # -- # provided with the distribution. # -- # # -- # 3. Neither the name of the copyright holder nor the names of its contributors may be used to # -- # endorse or promote products derived from this software without specific prior written # -- # permission. # -- # # -- # THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS # -- # OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF # -- # MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE # -- # COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, # -- # EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE # -- # GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED # -- # AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING # -- # NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED # -- # OF THE POSSIBILITY OF SUCH DAMAGE. # -- # ********************************************************************************************* # -- # The NEORV32 Processor - https://github.com/stnolting/neorv32 (c) Stephan Nolting # -- ################################################################################################# library ieee; use ieee.std_logic_1164.all; use ieee.numeric_std.all; library neorv32; use neorv32.neorv32_package.all; entity neorv32_xirq is generic ( XIRQ_NUM_CH : natural; -- number of external IRQ channels (0..32) XIRQ_TRIGGER_TYPE : std_ulogic_vector(31 downto 0); -- trigger type: 0=level, 1=edge XIRQ_TRIGGER_POLARITY : std_ulogic_vector(31 downto 0) -- trigger polarity: 0=low-level/falling-edge, 1=high-level/rising-edge ); port ( -- host access -- clk_i : in std_ulogic; -- global clock line addr_i : in std_ulogic_vector(31 downto 0); -- address rden_i : in std_ulogic; -- read enable wren_i : in std_ulogic; -- write enable data_i : in std_ulogic_vector(31 downto 0); -- data in data_o : out std_ulogic_vector(31 downto 0); -- data out ack_o : out std_ulogic; -- transfer acknowledge -- external interrupt lines -- xirq_i : in std_ulogic_vector(31 downto 0); -- CPU interrupt -- cpu_irq_o : out std_ulogic ); end neorv32_xirq; architecture neorv32_xirq_rtl of neorv32_xirq is -- IO space: module base address -- constant hi_abb_c : natural := index_size_f(io_size_c)-1; -- high address boundary bit constant lo_abb_c : natural := index_size_f(xirq_size_c); -- low address boundary bit -- access control -- signal acc_en : std_ulogic; -- module access enable signal addr : std_ulogic_vector(31 downto 0); -- access address signal wren : std_ulogic; -- word write enable signal rden : std_ulogic; -- read enable -- control registers -- signal irq_enable : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); -- r/w: interrupt enable signal clr_pending : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); -- r/w: clear pending IRQs signal irq_src : std_ulogic_vector(4 downto 0); -- r/w: source IRQ, ACK on any write -- interrupt trigger -- signal irq_sync : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); signal irq_sync2 : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); signal irq_trig : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); -- interrupt buffer -- signal irq_buf : std_ulogic_vector(XIRQ_NUM_CH-1 downto 0); signal irq_fire : std_ulogic; -- interrupt source -- signal irq_src_nxt : std_ulogic_vector(4 downto 0); -- arbiter -- signal irq_run : std_ulogic; begin -- Sanity Checks -------------------------------------------------------------------------- -- ------------------------------------------------------------------------------------------- assert not ((XIRQ_NUM_CH < 0) or (XIRQ_NUM_CH > 32)) report "NEORV32 PROCESSOR CONFIG ERROR: Number of XIRQ inputs <XIRQ_NUM_CH> has to be 0..32." severity error; -- Access Control ------------------------------------------------------------------------- -- ------------------------------------------------------------------------------------------- acc_en <= '1' when (addr_i(hi_abb_c downto lo_abb_c) = xirq_base_c(hi_abb_c downto lo_abb_c)) else '0'; addr <= xirq_base_c(31 downto lo_abb_c) & addr_i(lo_abb_c-1 downto 2) & "00"; -- word aligned wren <= acc_en and wren_i; rden <= acc_en and rden_i; -- Read/Write Access ---------------------------------------------------------------------- -- ------------------------------------------------------------------------------------------- rw_access: process(clk_i) begin if rising_edge(clk_i) then -- bus handshake -- ack_o <= rden or wren; -- write access -- clr_pending <= (others => '1'); if (wren = '1') then -- channel-enable -- if (addr = xirq_enable_addr_c) then irq_enable <= data_i(XIRQ_NUM_CH-1 downto 0); end if; -- clear pending IRQs -- if (addr = xirq_pending_addr_c) then clr_pending <= data_i(XIRQ_NUM_CH-1 downto 0); -- set zero to clear pending IRQ end if; end if; -- read access -- data_o <= (others => '0'); if (rden = '1') then case addr is when xirq_enable_addr_c => data_o(XIRQ_NUM_CH-1 downto 0) <= irq_enable; -- channel-enable when xirq_pending_addr_c => data_o(XIRQ_NUM_CH-1 downto 0) <= irq_buf; -- pending IRQs when xirq_source_addr_c => data_o(4 downto 0) <= irq_src; -- source IRQ when others => NULL; end case; end if; end if; end process rw_access; -- IRQ Trigger -------------------------------------------------------------- -- ----------------------------------------------------------------------------- irq_trigger: process(clk_i) begin if rising_edge(clk_i) then irq_sync <= xirq_i(XIRQ_NUM_CH-1 downto 0); irq_sync2 <= irq_sync; end if; end process irq_trigger; irq_trigger_comb: process(irq_sync, irq_sync2) variable sel_v : std_ulogic_vector(1 downto 0); begin for i in 0 to XIRQ_NUM_CH-1 loop sel_v := XIRQ_TRIGGER_TYPE(i) & XIRQ_TRIGGER_POLARITY(i); case sel_v is when "00" => irq_trig(i) <= not irq_sync(i); -- low-level when "01" => irq_trig(i) <= irq_sync(i); -- high-level when "10" => irq_trig(i) <= (not irq_sync(i)) and irq_sync2(i); -- falling-edge when "11" => irq_trig(i) <= irq_sync(i) and (not irq_sync2(i)); -- rising-edge when others => irq_trig(i) <= '0'; end case; end loop; end process irq_trigger_comb; -- IRQ Buffer --------------------------------------------------------------- -- ----------------------------------------------------------------------------- irq_buffer: process(clk_i) begin if rising_edge(clk_i) then irq_buf <= (irq_buf or (irq_trig and irq_enable)) and clr_pending; end if; end process irq_buffer; -- anyone firing? -- irq_fire <= or_reduce_f(irq_buf); -- IRQ Priority Encoder ----------------------------------------------------- -- ----------------------------------------------------------------------------- irq_priority: process(irq_buf) begin irq_src_nxt <= (others => '0'); if (XIRQ_NUM_CH > 1) then for i in 0 to XIRQ_NUM_CH-1 loop if (irq_buf(i) = '1') then irq_src_nxt(index_size_f(XIRQ_NUM_CH)-1 downto 0) <= std_ulogic_vector(to_unsigned(i, index_size_f(XIRQ_NUM_CH))); exit; end if; end loop; end if; end process irq_priority; -- IRQ Arbiter -------------------------------------------------------------- -- ----------------------------------------------------------------------------- irq_arbiter: process(clk_i) begin if rising_edge(clk_i) then cpu_irq_o <= '0'; if (irq_run = '0') then -- no active IRQ if (irq_fire = '1') then cpu_irq_o <= '1'; irq_run <= '1'; irq_src <= irq_src_nxt; end if; else -- active IRQ, wait for CPU to acknowledge if (wren = '1') and (addr = xirq_source_addr_c) then -- write _any_ value to acknowledge irq_run <= '0'; end if; end if; end if; end process irq_arbiter; end neorv32_xirq_rtl;
Go to most recent revision | Compare with Previous | Blame | View Log