OpenCores
URL https://opencores.org/ocsvn/open8_urisc/open8_urisc/trunk

Subversion Repositories open8_urisc

[/] [open8_urisc/] [trunk/] [VHDL/] [vector_tx.vhd] - Rev 285

Go to most recent revision | Compare with Previous | Blame | View Log

-- Copyright (c)2020 Jeremy Seth Henry
-- All rights reserved.
--
-- Redistribution and use in source and binary forms, with or without
-- modification, are permitted provided that the following conditions are met:
--     * Redistributions of source code must retain the above copyright
--       notice, this list of conditions and the following disclaimer.
--     * Redistributions in binary form must reproduce the above copyright
--       notice, this list of conditions and the following disclaimer in the
--       documentation and/or other materials provided with the distribution,
--       where applicable (as part of a user interface, debugging port, etc.)
--
-- THIS SOFTWARE IS PROVIDED BY JEREMY SETH HENRY ``AS IS'' AND ANY
-- EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
-- WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
-- DISCLAIMED. IN NO EVENT SHALL JEREMY SETH HENRY BE LIABLE FOR ANY
-- DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
-- (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
-- LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
-- ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
-- (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS
-- SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
--
-- VHDL Entity: vector_tx
-- Description: Reads  the pushbuttons and switches on the DE1-SOC board and
--               sends a vector command and argument to a vector_rx receiver
--               which executes them in lieu of a parallel controller.
--
-- Revision History
-- Author          Date     Change
------------------ -------- ---------------------------------------------------
-- Seth Henry      05/06/20 Added version block
-- Seth Henry      04/07/21 Modified to replace hard-coded blocks with true
--                           argument inputs.
 
library ieee;
  use ieee.std_logic_1164.all;
  use ieee.std_logic_unsigned.all;
  use ieee.std_logic_arith.all;
  use ieee.std_logic_misc.all;
 
library work;
  use work.open8_pkg.all;
 
entity vector_tx is
generic(
  Button_Level               : std_logic;
  Bit_Rate                   : real;
  Enable_Parity              : boolean;
  Parity_Odd_Even_n          : std_logic;
  Sys_Freq                   : real;
  Reset_Level                : std_logic
);
port(
  Clock                      : in  std_logic;
  Reset                      : in  std_logic;
  --
  Tx_Enable                  : in  std_logic;
  Tx_Command                 : in  DATA_TYPE;
  Tx_Arg_Lower               : in  DATA_TYPE;
  Tx_Arg_Upper               : in  DATA_TYPE;
  --
  Tx_Busy                    : out std_logic;
  --
  Tx_Out                     : out std_logic;
  Tx_FC                      : in  std_logic := '1'
);
end entity;
 
architecture behave of vector_tx is
 
  signal Command_Buffer      : DATA_TYPE := x"00";
  signal Arg_Lower_Buffer    : DATA_TYPE := x"00";
  signal Arg_Upper_Buffer    : DATA_TYPE := x"00";
 
  type VECTOR_TX_STATES is (IDLE,
                            SEND_CMD, WAIT_CMD,
                            SEND_ARG_LB, WAIT_ARG_LB,
                            SEND_ARG_UB, WAIT_ARG_UB,
                            SEND_SUM, WAIT_SUM );
  signal Vector_State        : VECTOR_TX_STATES := IDLE;
 
  constant BAUD_RATE_DIV     : integer := integer(Sys_Freq / Bit_Rate);
 
  constant MAGIC_NUM         : DATA_TYPE := x"4D";
  signal Checksum            : DATA_TYPE := x"00";
 
  signal Tx_Data             : DATA_TYPE := x"00";
  signal Tx_Valid            : std_logic := '0';
  signal Tx_Done             : std_logic := '0';
 
begin
 
  TX_FSM_proc: process( Clock, Reset )
  begin
    if( Reset = Reset_Level )then
      Vector_State           <= IDLE;
      Command_Buffer         <= x"00";
      Arg_Lower_Buffer       <= x"00";
      Arg_Upper_Buffer       <= x"00";
      Tx_Busy                <= '0';
      Tx_Data                <= x"00";
      Tx_Valid               <= '0';
    elsif( rising_edge(Clock) )then
      Tx_Busy                <= '1';
      Tx_Data                <= x"00";
      Tx_Valid               <= '0';
      case( Vector_State )is
        when IDLE =>
          Tx_Busy            <= '0';
          Checksum           <= MAGIC_NUM;
          if( Tx_Enable = '1' )then
            Command_Buffer   <= Tx_Command;
            Arg_Lower_Buffer <= Tx_Arg_Lower;
            Arg_Upper_Buffer <= Tx_Arg_Upper;
            Vector_State     <= SEND_CMD;
          end if;
 
        when SEND_CMD =>
          Tx_Data            <= Command_Buffer;
          Tx_Valid           <= '1';
          Checksum           <= Checksum + Command_Buffer;
          Vector_State       <= WAIT_CMD;
 
        when WAIT_CMD =>
          if( Tx_Done = '1' )then
            Vector_State     <= SEND_ARG_LB;
          end if;
 
        when SEND_ARG_LB =>
          Tx_Data            <= Arg_Lower_Buffer;
          Tx_Valid           <= '1';
          Checksum           <= Checksum + Arg_Lower_Buffer;
          Vector_State       <= WAIT_ARG_LB;
 
        when WAIT_ARG_LB =>
          if( Tx_Done = '1' )then
            Vector_State     <= SEND_ARG_UB;
          end if;
 
        when SEND_ARG_UB =>
          Tx_Data            <= Arg_Upper_Buffer;
          Tx_Valid           <= '1';
          Checksum           <= Checksum + Arg_Upper_Buffer;
          Vector_State       <= WAIT_ARG_UB;
 
        when WAIT_ARG_UB =>
          if( Tx_Done = '1' )then
            Vector_State     <= SEND_SUM;
          end if;
 
        when SEND_SUM =>
          Tx_Data            <= Checksum;
          Tx_Valid           <= '1';
          Vector_State       <= WAIT_SUM;
 
        when WAIT_SUM =>
          if( Tx_Done = '1' )then
            Vector_State     <= IDLE;
          end if;
 
      end case;
    end if;
  end process;
 
  U_TX : entity work.async_ser_tx
  generic map(
    Reset_Level              => Reset_Level,
    Enable_Parity            => Enable_Parity,
    Parity_Odd_Even_n        => Parity_Odd_Even_n,
    Clock_Divider            => BAUD_RATE_DIV
  )
  port map(
    Clock                    => Clock,
    Reset                    => Reset,
    --
    Tx_Data                  => Tx_Data,
    Tx_Valid                 => Tx_Valid,
    --
    Tx_Out                   => Tx_Out,
    Tx_Done                  => Tx_Done
  );
 
end architecture;

Go to most recent revision | Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.