URL
https://opencores.org/ocsvn/openarty/openarty/trunk
Subversion Repositories openarty
[/] [openarty/] [trunk/] [rtl/] [xoddr.v] - Rev 39
Go to most recent revision | Compare with Previous | Blame | View Log
//////////////////////////////////////////////////////////////////////////////// // // Filename: xoddr.v // // Project: OpenArty, an entirely open SoC based upon the Arty platform // // Purpose: For the DDR3 SDRAM, this handles the Xilinx specific portions // of the output necessary to make this happen for one pin only. // For the QSPI, this helps to make certain that as much of the logic // delay as possible has been removed from the path--to get the full // 100MHz speed. // // Creator: Dan Gisselquist, Ph.D. // Gisselquist Technology, LLC // //////////////////////////////////////////////////////////////////////////////// // // Copyright (C) 2015-2016, Gisselquist Technology, LLC // // This program is free software (firmware): you can redistribute it and/or // modify it under the terms of the GNU General Public License as published // by the Free Software Foundation, either version 3 of the License, or (at // your option) any later version. // // This program is distributed in the hope that it will be useful, but WITHOUT // ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or // FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License // for more details. // // You should have received a copy of the GNU General Public License along // with this program. (It's in the $(ROOT)/doc directory, run make with no // target there if the PDF file isn't present.) If not, see // <http://www.gnu.org/licenses/> for a copy. // // License: GPL, v3, as defined and found on www.gnu.org, // http://www.gnu.org/licenses/gpl.html // // //////////////////////////////////////////////////////////////////////////////// // // module xoddr(i_clk, i_v, o_pin); input i_clk; input [1:0] i_v; output o_pin; wire w_internal; reg last; always @(posedge i_clk) last <= i_v[1]; ODDR #( .DDR_CLK_EDGE("SAME_EDGE"), .INIT(1'b0), .SRTYPE("SYNC") ) ODDRi( .Q(o_pin), .C(i_clk), .CE(1'b1), .D1(last), // Negative clock edge (goes first) .D2(i_v[0]), // Positive clock edge .R(1'b0), .S(1'b0)); endmodule
Go to most recent revision | Compare with Previous | Blame | View Log