URL
https://opencores.org/ocsvn/openmsp430/openmsp430/trunk
Subversion Repositories openmsp430
[/] [openmsp430/] [trunk/] [fpga/] [xilinx_diligent_s3board/] [software/] [hw_uart/] [main.c] - Rev 216
Go to most recent revision | Compare with Previous | Blame | View Log
#include "omsp_system.h" #include "hardware.h" #include <stdlib.h> #include <stdio.h> //--------------------------------------------------// // Delay function // //--------------------------------------------------// void delay(unsigned int d) { while(d--) { __nop(); __nop(); } } //--------------------------------------------------// // tty_putc function // // (Send a byte to the UART) // //--------------------------------------------------// int tty_putc (int txdata) { // Wait until the TX buffer is not full while (UART_STAT & UART_TX_FULL); // Write the output character UART_TXD = txdata; return 0; } //--------------------------------------------------// // UART RX interrupt service routine // // (receive a byte from the UART) // //--------------------------------------------------// volatile char rxdata; wakeup interrupt (UART_RX_VECTOR) INT_uart_rx(void) { // Read the received data rxdata = UART_RXD; // Clear the receive pending flag UART_STAT = UART_RX_PND; // Exit the low power mode LPM0_EXIT; } //--------------------------------------------------// // Main function with init an an endless loop that // // is synced with the interrupts trough the // // lowpower mode. // //--------------------------------------------------// int main(void) { int reading = 0; int pos = 0; char buf[40]; int led = 0; WDTCTL = WDTPW | WDTHOLD; // Init watchdog timer P3DIR = 0xff; P3OUT = 0xff; // Light LED during init UART_BAUD = BAUD; // Init UART UART_CTL = UART_EN | UART_IEN_RX; // delay(65535); // Some delay //delay(65535); P3OUT = 0x00; // Switch off LED cprintf("\r\n====== openMSP430 in action ======\r\n"); //say hello cprintf("\r\nSimple Line Editor Ready\r\n"); eint(); // Enable interrupts while (1) { //main loop, never ends... cprintf("> "); //show prompt reading = 1; while (reading) { //loop and read characters LPM0; //sync, wakeup by irq led++; // Some lighting... if (led==9) { led = 0; } P3OUT = (0x01 << led); switch (rxdata) { //process RETURN key case '\r': //case '\n': cprintf("\r\n"); //finish line buf[pos++] = 0; //to use cprintf... cprintf(":%s\r\n", buf); reading = 0; //exit read loop pos = 0; //reset buffer break; //backspace case '\b': if (pos > 0) { //is there a char to delete? pos--; //remove it in buffer tty_putc('\b'); //go back tty_putc(' '); //erase on screen tty_putc('\b'); //go back } break; //other characters default: //only store characters if buffer has space if (pos < sizeof(buf)) { tty_putc(rxdata); //echo buf[pos++] = rxdata; //store } } } } }
Go to most recent revision | Compare with Previous | Blame | View Log