Subversion Repositories openrisc

                                WORLD

This is a program that uses mini-X graphics in MINIX to display a map of
the world.  The database for this map is supplied, and is an edited version
of the CIA database.  The continents, islands, rivers, lakes, countries,
and the states of the USA are shown.  I have slightly edited the database
to fix some arctic islands and remove the Berlin corridor.  But some country
boundaries are obsolete, since this map is a few years old at least.

This program only uses integer arithmetic.  Floating point is simulated
using fixed point arithmetic.  For this reason, the projection used in
the program is rather crude (latitude and longitude are linear and are
parallel lines).  This means that there is much distortion for the lands
which are near the North and South poles.  If floating point was avaiable,
a good projection could be used instead (such as a true spherical view!).

The file "world.map" is the database, and should be installed in "/usr/lib".
Otherwise you need to edit world.c and change MAPFILE as desired.

To build the program (assuming mini-X is installed), use the command:

        cc -o world world.c -lgraph

When the program starts, it draws the whole world.  After this is done,
you can use two of the mouse buttons and the keys to manipulate the view.

To zoom in on a section of the map, move the mouse to the location that
you intend to zoom in on, and press the left mouse button.  Then when you
drag the mouse, a rectangle (the zoom box) will be drawn to indicate the
current area that you are zooming into.  Notice that the point that you
start the zoom box on will be the center of the zoom box, NOT one of its
corners.

While keeping the mouse button pressed, you can use the 's' and 'm' keys
to switch between the 'scaling' and the 'moving' modes of the rectangle.
The scaling mode makes the size of the zoom box vary as you move the mouse,
but keeps the center of the zoom box fixed.  The moving mode keeps the size
of the zoom box the same, but moves the box around as you move the mouse.
Note that the width and height of the zoom box change together to preserve
the aspect ratio of the zoom area.

If you have started to do a zoom, but change your mind, then you can type
the escape key before letting up on the mouse button, and this will cancel
the zoom operation.  If you really want to do a zoom, then simply let up
on the mouse button and the selected area will be redrawn to fit the screen.
At this point you can zoom in further if you wish.

You can return to the top level map by typing 't'.  Then you can zoom in
again on a different area of the map.  Alternatively, you can "zoom out"
just a little by creating a zoom box larger than the screen size.  This can
be done, for example, by starting a zoom near the top of the screen, and then
dragging the mouse down to the bottom of the screen.  Repeating this process
lets you slowly reduce the magnification.

If you press the right mouse button, the display will show the longitude
and latitude of the location on the map covered by the cursor.  You can then
drag the mouse around with the button held down, and the coordinates will
continuously track the cursor location.  Letting up on the mouse button
removes the coordinate display.

Typing 'q' will quit from the world program.

Enjoy!
David I. Bell