URL
https://opencores.org/ocsvn/openrisc/openrisc/trunk
Subversion Repositories openrisc
[/] [openrisc/] [trunk/] [rtos/] [freertos-6.1.1/] [Demo/] [HCS12_CodeWarrior_banked/] [DOC/] [RTOSDemo.txt] - Rev 636
Go to most recent revision | Compare with Previous | Blame | View Log
=============================================================================
List of methods in project: RTOSDemo
THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT.
=============================================================================
Module "TickTimer" (bean TimerInt)
TickTimer_Enable -Enable the bean - it starts the timer. Events may be generated ("DisableEvent"/"EnableEvent").
TickTimer_SetPeriodTicks16 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]
as a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
selected in the <Timing dialog box> in Runtime setting area.
TickTimer_SetPeriodTicks32 -This method sets the new period of the generated events. The period is expressed in CPU [ticks]
as a 32-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
selected in the <Timing dialog box> in Runtime setting area.
TickTimer_SetPeriodUS -This method sets the new period of the generated events. The period is expressed in [microseconds] as
a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
selected in the <Timing dialog box> in Runtime setting area.
TickTimer_SetPeriodMS -This method sets the new period of the generated events. The period is expressed in [miliseconds] as
a 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
selected in the <Timing dialog box> in Runtime setting area.
TickTimer_SetFreqHz -This method sets the new frequency of the generated events. The frequency is expressed in [Hz] as a
16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is
selected in the <Timing dialog box> in Runtime setting area.
Module "Byte1" (bean ByteIO)
Byte1_PutBit -Put the specified value to the specified bit/pin of the Input/Output bean. If direction is [input] saves the
value to a memory or a register, this value will be written to the pin after switching to the output mode -
using [SetDir(TRUE)]. If direction is [output] writes the value to the pin.
Byte1_NegBit -Negate (invert) the specified bit of the Input/Output bean. It is the same as [PutBit(Bit,!GetBit(Bit))].
Module "COM0" (bean AsynchroSerial)
COM0_SetBaudRateMode -This method changes the channel communication speed (baud rate). This method can be used only if you
specify a list of possible period settings at design time (see <Timing dialog box> - Runtime setting - from a
list of values). Each of these settings constitutes a mode and Processor Expert^[TM] assigns them a mode
identifier. The prescaler and compare values corresponding to each mode are calculated at design time. You may
switch modes at runtime by referring only to a mode identifier. No run-time calculations are performed, all the
calculations are performed at design time.
Module "Cpu" (bean MC9S12DP256_112)
Cpu_EnableInt -Enable maskable interrupts
Cpu_DisableInt -Disable maskable interrupts
=============================================================================
Go to most recent revision | Compare with Previous | Blame | View Log