OpenCores
URL https://opencores.org/ocsvn/or1k/or1k/trunk

Subversion Repositories or1k

[/] [or1k/] [branches/] [oc/] [xess/] [xsv_cpld/] [syn/] [xilinx_pr/] [xsv_cpld.ucf] - Rev 1765

Compare with Previous | Blame | View Log

#
# pin assignments for the XC95108 CPLD chip on the XSV Board
#

# set all the bits in the initial state of the power-on
# counter so we get the maximum timeout interval
#INST poweron_cnt_reg[*] INIT = S;

# Virtex FPGA
NET "V_dout"            LOC = "p6";
NET "V_wrb"             LOC = "p7";
NET "V_csb"             LOC = "p8";
NET "V_initb"           LOC = "p9";
NET "V_done"            LOC = "p10";
NET "V_progb"           LOC = "p11";
NET "V_cclk"            LOC = "p12";
NET "V_m[0]"            LOC = "p13";
NET "V_m[1]"            LOC = "p14";
NET "V_m[2]"            LOC = "p15";

# Flash RAM
NET "resetb"            LOC = "p3";
NET "ceb"               LOC = "P46";
NET "oeb"               LOC = "p42";
NET "web"               LOC = "p43";
NET "a[0]"              LOC = "p16";
NET "a[1]"              LOC = "p17";
NET "a[2]"              LOC = "p18";
NET "a[3]"              LOC = "p19";
NET "a[4]"              LOC = "p20";
NET "a[5]"              LOC = "p23";
NET "a[6]"              LOC = "p24";
NET "a[7]"              LOC = "p25";
NET "a[8]"              LOC = "p27";
NET "a[9]"              LOC = "p28";
NET "a[10]"             LOC = "p29";
NET "a[11]"             LOC = "p30";
NET "a[12]"             LOC = "p49";
NET "a[13]"             LOC = "p50";
NET "a[14]"             LOC = "p52";
NET "a[15]"             LOC = "p53";
NET "a[16]"             LOC = "p54";
NET "a[17]"             LOC = "p55";
NET "a[18]"             LOC = "p56";
NET "a[19]"             LOC = "p58";
NET "a[20]"             LOC = "p59";

# programmable oscillator
NET "clk"               LOC = "p22";

# parallel port
#NET "ppd[0]"              LOC = "p77";
#NET "ppd[1]"              LOC = "p74";
NET "ppd[2]"              LOC = "p72";
NET "ppd[3]"              LOC = "p70";
NET "ppd[4]"              LOC = "p68";
NET "ppd[5]"              LOC = "p67";
#NET "ppd[6]"              LOC = "p66";
#NET "ppd[7]"              LOC = "p65";
#NET "ppc[0]"              LOC = "p79";
#NET "ppc[1]"              LOC = "p78";
#NET "ppc[3]"              LOC = "p71";
#NET "pps[3]"              LOC = "p76";
#NET "pps[4]"              LOC = "p60";
NET "pps[5]"              LOC = "p61";
#NET "pps[6]"              LOC = "p64";

# UART
NET "rxd" LOC = "p80";    # Connected to RS232
NET "txd" LOC = "p81";    # Connected to RS232
#NET "TXD1" LOC = "p9";    # INIT on Virtex = I/O after configuration
#NET "RXD1" LOC = "p8";    # CS on Virtex = I/O after configuration unless the SelectMAP port is retained.

# Ethernet
NET "eth_leds"          LOC = "p1";
NET "eth_ledr"          LOC = "p95";
NET "eth_ledt"          LOC = "p96";
NET "eth_ledl"          LOC = "p97";
NET "eth_ledc"          LOC = "p98";
NET "eth_mf[0]"         LOC = "p91";
NET "eth_mf[1]"         LOC = "p90";
NET "eth_mf[2]"         LOC = "p89";
NET "eth_mf[3]"         LOC = "p87";
NET "eth_mf[4]"         LOC = "p86";
NET "eth_cfg[0]"        LOC = "p93";
NET "eth_cfg[1]"        LOC = "p2";
NET "eth_mddis"         LOC = "p94";
NET "eth_fde"           LOC = "p92";

Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.