Subversion Repositories or1k

#define DW 32	/* Data width of memory model generated by dumpverilog in bits */
#define DWQ (DW/8) /* Same as DW but units are bytes */
#define DISWIDTH 20 /* Width of disassembled message in bytes */
 
#define OR1K_MEM_VERILOG_HEADER(MODNAME, FROMADDR, TOADDR, DISWIDTH) "\n\
`include \"general.h\"\n\n\
`timescale 1ns/100ps\n\n\
// Simple dw-wide Sync SRAM with initial content generated by or1ksim.\n\
// All control, data in and addr signals are sampled at rising clock edge  \n\
// Data out is not registered. Address bits specify dw-word (narrowest \n\
// addressed data is not byte but dw-word !). \n
// There are still some bugs in generated output (dump word aligned regions)\n\n\
module %s(clk, data, addr, ce, we);\n\n\
parameter dw = 32;\n\
parameter amin = %d;\n\n\
parameter amax = %d;\n\n\
input clk;\n\
inout [dw-1:0] data;\n\
input [31:0] addr;\n\
input ce;\n\
input we;\n\n\
reg  [dw-1:0] mem [amax:amin];\n\
reg  [%d-1:0] dis [amax:amin];\n\
reg  [dw-1:0] dataout;\n\
tri  [dw-1:0] data = (ce && ~we) ? dataout : 'bz;\n\n\
initial begin\n", MODNAME, FROMADDR, TOADDR, DISWIDTH
 
#define OR1K_MEM_VERILOG_FOOTER "\n\
end\n\n\
always @(posedge clk) begin\n\
        if (ce && ~we) begin\n\
                dataout <= #1 mem[addr];\n\
                $display(\"or1k_mem: reading mem[%%0d]:%%h dis: %%0s\", addr, dataout, dis[addr]);\n\
        end else\n\
        if (ce && we) begin\n\
                mem[addr] <= #1 data;\n\
                dis[addr] <= #1 \"(data)\";\n\
                $display(\"or1k_mem: writing mem[%%0d]:%%h dis: %%0s\", addr, mem[addr], dis[addr]);\n\
        end\n\
end\n\n\
endmodule\n"