URL
https://opencores.org/ocsvn/or1k/or1k/trunk
Subversion Repositories or1k
[/] [or1k/] [trunk/] [insight/] [dejagnu/] [baseboards/] [cf.exp] - Rev 1767
Go to most recent revision | Compare with Previous | Blame | View Log
# This is a list of toolchains that are supported on this board.
set_board_info target_install {m68k-elf};
# Load the generic configuration for this board. This will define any
# routines needed by the tool to communicate with the board.
load_generic_config "cfdbug";
# Need -m5200 by default.
process_multilib_options "-m5200"
# The compiler used to build for this board. Note that this has nothing to do
# with what compiler is tested when testing gcc.
set_board_info compiler "[find_gcc]"
set_board_info cflags "[newlib_include_flags] [libgloss_include_flags]";
# Nasty hack.
if { [board_info $board obj_format] == "a.out" } {
# Need to pass the start address to objcopy.
set_board_info use_vma_offset 1;
# Wrapping has to be specially done for m68k-aout, for whatever reason.
set_board_info wrap_m68k_aout 1;
set extra_m68k_ld_flags "-N"
# We need to tell GDB to load at the correct offset.
set_board_info gdb_load_offset [board_info $board hex_startaddr];
} else {
set extra_m68k_ld_flags ""
}
set_board_info ldflags "$extra_m68k_ld_flags [libgloss_link_flags] [newlib_link_flags]"
unset extra_m68k_ld_flags
# If no output format is specified, use objcopy.
if ![board_info $board exists output_format] {
set tempfil [lookfor_file $tool_root_dir binutils/objcopy];
if { $tempfil != "" } {
set_board_info objcopy $tempfil
} else {
set_board_info objcopy [transform objcopy]
}
unset tempfil
}
# SBC5204 linker script.
set_board_info ldscript "-Wl,-Tsbc5204.ld";
# The idt interface can't return exit statuses, so gcc (ctorture et
# al) needs to do what it can to get them.
set_board_info needs_status_wrapper 1;
# Used by a few gcc.c-torture testcases to delimit how large the stack can be.
# The board has 192K of RAM. We will set stack size to one third of that.
set_board_info gcc,stack_size 65536
# GDB needs to use "target dbug" to talk to the board.
set_board_info gdb_protocol "dbug";
# Can't pass arguments to the program under test.
set_board_info noargs 1
# Nor can it do I/O in GDB.
set_board_info gdb,noinferiorio 1
# It has no signals.
set_board_info gdb,nosignals 1
# It can't return results when debugging with GDB.
set_board_info gdb,noresults 1
# Pseudo-random guess.
set_board_info sys_speed_value 200;
Go to most recent revision | Compare with Previous | Blame | View Log