Subversion Repositories or1k

1998-12-04  Andrew T. Veliath  <andrewtv@usa.net>

        * Update version to 0.8.2.2

        * Add msndreset program to shell archive.

1998-11-11  Andrew T. Veliath  <andrewv@usa.net>

        * msnd_pinnacle.c (mixer_ioctl): Add a mixer ioctl for
        SOUND_MIXER_PRIVATE1 which does a full reset on the card.
        (mixer_set): Move line in recording source to input monitor, aux
        input level added, some mixer fixes.

1998-09-10  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.8.2

        * Add SNDCTL_DSP_GETOSPACE and SNDCTL_DSP_GETISPACE ioctls.

1998-09-09  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.8.1
        
        * msnd_pinnacle.c: Fix resetting of default audio parameters. Turn
        flush code from dsp_halt into dsp_write_flush, and use that for
        SNDCTL_DSP_SYNC.

1998-09-07  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.8.0

        * Provide separate signal parameters for play and record.
        
        * Cleanups to locking and interrupt handling, change default
        fifosize to 128kB.

        * Update version to 0.7.15

        * Interprocess full-duplex support (ie `cat /dev/dsp > /dev/dsp').

        * More mutex sections for read and write fifos (read + write locks
        added).

1998-09-05  Andrew Veliath  <andrewtv@usa.net>

        * msnd_pinnacle.c: (chk_send_dsp_cmd) Do full DSP reset upon DSP
        timeout (when not in interrupt; maintains mixer settings).  Fixes
        to flushing and IRQ ref counting. Rewrote queuing for smoother
        playback and fixed initial playback cutoff problem.

1998-09-03  Andrew Veliath  <andrewtv@usa.net>

        * Replaced packed structure accesses with standard C equivalents.

1998-09-01  Andrew Veliath  <andrewtv@usa.net>

        * msnd_pinnacle.c: Add non-PnP configuration to driver code, which
          will facilitate compiled-in operation.

1998-08-29  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.7.6
        
        * msnd_pinnacle.c (dsp_ioctl): Add DSP_GETFMTS, change SAMPLESIZE
          to DSP_SETFMT.

        * Update version to 0.7.5
        
        * Create pinnaclecfg.c and turn MultiSound doc into a shell
          archive with pinnaclecfg.c included.  pinnaclecfg.c can
          now fully configure the card in non-PnP mode, including the
          joystick and IDE controller.  Also add an isapnp conf
          example.

        * Reduce DSP reset timeout from 20000 to 100

1998-08-06  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.7.2
        
        * After A/D calibration, do an explicit set to the line input,
          rather than using set_recsrc

1998-07-20  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.7.1

        * Add more OSS ioctls
        
1998-07-19  Andrew Veliath  <andrewtv@usa.net>

        * Update doc file
        
        * Bring back DIGITAL1 with digital parameter to msnd_pinnacle.c
          and CONFIG_MSNDPIN_DIGITAL.  I'm not sure this actually works,
          since I find audio playback goes into a very speeded mode of
          operation, however it might be due to a lack of a digital
          source, which I don't have to test.

1998-07-18  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.7.0

        * Can now compile with Alan Cox' 2.0.34-modular-sound patch (so
          now it requires >= 2.1.106 or 2.0.34-ms) (note for 2.0.34-ms it
          is in the Experimental section)

        * More modularization, consolidation, also some MIDI hooks
          installed for future MIDI modules

        * Write flush

        * Change default speed, channels, bit size to OSS/Free defaults

1998-06-02  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.5b

        * Fix version detection
        
        * Remove underflow and overflow resets (delay was too long)

        * Replace spinlocked bitops with atomic bit ops

1998-05-27  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.5a
        
        * Better recovery from underflow or overflow conditions
        
        * Fix a deadlock condition with one thread reading and the other
          writing

1998-05-26  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.5
        
        * Separate reset queue functions for play and record

        * Add delays in dsp_halt

1998-05-24  Andrew Veliath  <andrewtv@usa.net>

        * Add a check for Linux >= 2.1.95
        
        * Remove DIGITAL1 input until I figure out how to make it work
        
        * Add HAVE_DSPCODEH which when not defined will load firmware from
          files using mod_firmware_load, then release memory after they
          are uploaded (requires reorganized OSS).

1998-05-22  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.4c

        * Hopefully fix the mixer volume problem

1998-05-19  Andrew Veliath  <andrewtv@usa.net>

        * Add __initfuncs and __initdatas to reduce resident code size

        * Move bunch of code around, remove some protos

        * Integrate preliminary changes for Alan Cox's OSS reorganization
          for non-OSS drivers to coexist with OSS devices on the same
          major.  To compile standalone, must now define STANDALONE.

1998-05-16  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.4b
        
        * Integrated older card support into a unified driver, tested on a
          MultiSound Classic c/o Kendrick Vargas.

1998-05-15  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.4
        
        * Fix read/write return values

1998-05-13  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.3

        * Stop play gracefully

        * Add busy flag
        
        * Add major and calibrate_signal module parameters
        
        * Add ADC calibration

        * Add some OSS compatibility ioctls

        * Add mixer record selection
        
        * Add O_NONBLOCK support, separate read/write wait queues

        * Add sample bit size ioctl, expanded sample rate ioctl

        * Playback suspension now resumes

        * Use signal_pending after interruptible_sleep_on
        
        * Add recording, change ints to bit flags

1998-05-11  Andrew Veliath  <andrewtv@usa.net>

        * Update version to 0.2

        * Add preliminary playback support

        * Use new Turtle Beach DSP code