OpenCores
URL https://opencores.org/ocsvn/or1k/or1k/trunk

Subversion Repositories or1k

[/] [or1k/] [trunk/] [newlib-1.10.0/] [newlib/] [libc/] [signal/] [signal.tex] - Rev 1765

Compare with Previous | Blame | View Log

@node Signals
@chapter Signal Handling (@file{signal.h})
 
A @dfn{signal} is an event that interrupts the normal flow of control
in your program.  Your operating environment normally defines the full
set of signals available (see @file{sys/signal.h}), as well as the
default means of dealing with them---typically, either printing an
error message and aborting your program, or ignoring the signal.
 
All systems support at least the following signals:
@table @code
@item SIGABRT
Abnormal termination of a program; raised by the <<abort>> function.
 
@item SIGFPE
A domain error in arithmetic, such as overflow, or division by zero.
 
@item SIGILL
Attempt to execute as a function data that is not executable.
 
@item SIGINT
Interrupt; an interactive attention signal.
 
@item SIGSEGV
An attempt to access a memory location that is not available.
 
@item SIGTERM
A request that your program end execution.
@end table
 
Two functions are available for dealing with asynchronous
signals---one to allow your program to send signals to itself (this is
called @dfn{raising} a signal), and one to specify subroutines (called
@dfn{handlers} to handle particular signals that you anticipate may
occur---whether raised by your own program or the operating environment.
 
To support these functions, @file{signal.h} defines three macros:
 
@table @code
@item SIG_DFL
Used with the @code{signal} function in place of a pointer to a
handler subroutine, to select the operating environment's default
handling of a signal.
 
@item SIG_IGN
Used with the @code{signal} function in place of a pointer to a
handler, to ignore a particular signal.
 
@item SIG_ERR
Returned by the @code{signal} function in place of a pointer to a
handler, to indicate that your request to set up a handler could not
be honored for some reason.
@end table
 
@file{signal.h} also defines an integral type, @code{sig_atomic_t}.
This type is not used in any function declarations; it exists only to
allow your signal handlers to declare a static storage location where
they may store a signal value.  (Static storage is not otherwise
reliable from signal handlers.)
 
@menu
* raise::   Send a signal
* signal::  Specify handler subroutine for a signal
@end menu
 
@page
@include signal/raise.def
 
@page
@include signal/signal.def
 

Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.