Subversion Repositories or1k

/* sound_config.h
 *
 * A driver for Soundcards, misc configuration parameters.
 */
/*
 * Copyright (C) by Hannu Savolainen 1993-1996
 *
 * USS/Lite for Linux is distributed under the GNU GENERAL PUBLIC LICENSE (GPL)
 * Version 2 (June 1991). See the "COPYING" file distributed with this software
 * for more info.
 */
 
 
#include "local.h"
#include "os.h"
#include "soundvers.h"
 
#if defined(ISC) || defined(SCO) || defined(SVR42)
#define GENERIC_SYSV
#endif
 
 
 
 
 
 
#ifndef SND_DEFAULT_ENABLE
#define SND_DEFAULT_ENABLE	1
#endif
 
#ifndef MAX_REALTIME_FACTOR
#define MAX_REALTIME_FACTOR	4
#endif
 
/************* PCM DMA buffer sizes *******************/
 
/* If you are using high playback or recording speeds, the default buffer size
   is too small. DSP_BUFFSIZE must be 64k or less.
 
   A rule of thumb is 64k for PAS16, 32k for PAS+, 16k for SB Pro and
   4k for SB.
 
   If you change the DSP_BUFFSIZE, don't modify this file.
   Use the make config command instead. */
 
#ifndef DSP_BUFFSIZE
#define DSP_BUFFSIZE		(4096)
#endif
 
#ifndef DSP_BUFFCOUNT
#define DSP_BUFFCOUNT		1	/* 1 is recommended. */
#endif
 
#define DMA_AUTOINIT		0x10
 
#define FM_MONO		0x388	/* This is the I/O address used by AdLib */
 
#ifndef PAS_BASE
#define PAS_BASE	0x388
#endif
 
#if defined(SB16_DMA) && !defined(SB_DMA2)
#  define SB_DMA2 SB16_DMA
#endif
 
#if defined(SB16MIDI_BASE) && !defined(SB_MPU_BASE)
#   define SB_MPU_BASE SB16MIDI_BASE
#endif
 
#ifndef SB_MPU_IRQ
#  define SB_MPU_IRQ SBC_IRQ
#endif
 
/* SEQ_MAX_QUEUE is the maximum number of sequencer events buffered by the
   driver. (There is no need to alter this) */
#define SEQ_MAX_QUEUE	1024
 
#define SBFM_MAXINSTR		(256)	/* Size of the FM Instrument bank */
/* 128 instruments for general MIDI setup and 16 unassigned	 */
 
/*
 * Minor numbers for the sound driver.
 *
 * Unfortunately Creative called the codec chip of SB as a DSP. For this
 * reason the /dev/dsp is reserved for digitized audio use. There is a
 * device for true DSP processors but it will be called something else.
 * In v3.0 it's /dev/sndproc but this could be a temporary solution.
 */
 
#define SND_NDEVS	256	/* Number of supported devices */
#define SND_DEV_CTL	0	/* Control port /dev/mixer */
#define SND_DEV_SEQ	1	/* Sequencer output /dev/sequencer (FM
				   synthesizer and MIDI output) */
#define SND_DEV_MIDIN	2	/* Raw midi access */
#define SND_DEV_DSP	3	/* Digitized voice /dev/dsp */
#define SND_DEV_AUDIO	4	/* Sparc compatible /dev/audio */
#define SND_DEV_DSP16	5	/* Like /dev/dsp but 16 bits/sample */
#define SND_DEV_STATUS	6	/* /dev/sndstat */
#define SND_DEV_AWFM	7	/* Reserved */
#define SND_DEV_SEQ2	8	/* /dev/sequencer, level 2 interface */
#define SND_DEV_SNDPROC 9	/* /dev/sndproc for programmable devices */
#define SND_DEV_PSS	SND_DEV_SNDPROC
 
#define DSP_DEFAULT_SPEED	8000
 
#define ON		1
#define OFF		0
 
#define MAX_AUDIO_DEV	5
#define MAX_MIXER_DEV	5
#define MAX_SYNTH_DEV	3
#define MAX_MIDI_DEV	6
#define MAX_TIMER_DEV	3
 
struct fileinfo {
       	  int mode;	      /* Open mode */
	  int flags;
	  int dummy;     /* Reference to file-flags. OS-dependent. */
       };
 
struct address_info {
	int io_base;
	int irq;
	int dma;
	int dma2;
	int always_detect;	/* 1=Trust me, it's there */
	char *name;
	int driver_use_1;	/* Driver defined field 1 */
	int driver_use_2;	/* Driver defined field 2 */
	int *osp;	/* OS specific info */
	int card_subtype;	/* Driver specific. Usually 0 */
};
 
#define SYNTH_MAX_VOICES	32
 
struct voice_alloc_info {
		int max_voice;
		int used_voices;
		int ptr;		/* For device specific use */
		unsigned short map[SYNTH_MAX_VOICES]; /* (ch << 8) | (note+1) */
		int timestamp;
		int alloc_times[SYNTH_MAX_VOICES];
	};
 
struct channel_info {
		int pgm_num;
		int bender_value;
		unsigned char controllers[128];
	};
 
/*
 * Process wakeup reasons
 */
#define WK_NONE		0x00
#define WK_WAKEUP	0x01
#define WK_TIMEOUT	0x02
#define WK_SIGNAL	0x04
#define WK_SLEEP	0x08
#define WK_SELECT	0x10
 
#define OPEN_READ	PCM_ENABLE_INPUT
#define OPEN_WRITE	PCM_ENABLE_OUTPUT
#define OPEN_READWRITE	(OPEN_READ|OPEN_WRITE)
 
#include "sound_calls.h"
#include "dev_table.h"
 
#ifndef DEB
#define DEB(x)
#endif
 
#ifndef DDB
#define DDB(x)
#endif
 
#define TIMER_ARMED	121234
#define TIMER_NOT_ARMED	1