OpenCores
URL https://opencores.org/ocsvn/or1k_soc_on_altera_embedded_dev_kit/or1k_soc_on_altera_embedded_dev_kit/trunk

Subversion Repositories or1k_soc_on_altera_embedded_dev_kit

[/] [or1k_soc_on_altera_embedded_dev_kit/] [tags/] [linux-2.6/] [linux-2.6.24_or32_unified_v2.3/] [net/] [mac80211/] [Kconfig] - Rev 8

Compare with Previous | Blame | View Log

config MAC80211
        tristate "Generic IEEE 802.11 Networking Stack (mac80211)"
        depends on EXPERIMENTAL
        select CRYPTO
        select CRYPTO_ECB
        select CRYPTO_ARC4
        select CRYPTO_AES
        select CRC32
        select WIRELESS_EXT
        select CFG80211
        select NET_SCH_FIFO
        ---help---
        This option enables the hardware independent IEEE 802.11
        networking stack.

config MAC80211_RCSIMPLE
        bool "'simple' rate control algorithm" if EMBEDDED
        default y
        depends on MAC80211
        help
          This option allows you to turn off the 'simple' rate
          control algorithm in mac80211. If you do turn it off,
          you absolutely need another rate control algorithm.

          Say Y unless you know you will have another algorithm
          available.

config MAC80211_LEDS
        bool "Enable LED triggers"
        depends on MAC80211 && LEDS_TRIGGERS
        ---help---
        This option enables a few LED triggers for different
        packet receive/transmit events.

config MAC80211_DEBUGFS
        bool "Export mac80211 internals in DebugFS"
        depends on MAC80211 && DEBUG_FS
        ---help---
          Select this to see extensive information about
          the internal state of mac80211 in debugfs.

          Say N unless you know you need this.

config MAC80211_DEBUG
        bool "Enable debugging output"
        depends on MAC80211
        ---help---
          This option will enable debug tracing output for the
          ieee80211 network stack.

          If you are not trying to debug or develop the ieee80211
          subsystem, you most likely want to say N here.

config MAC80211_VERBOSE_DEBUG
        bool "Verbose debugging output"
        depends on MAC80211_DEBUG

config MAC80211_LOWTX_FRAME_DUMP
        bool "Debug frame dumping"
        depends on MAC80211_DEBUG
        ---help---
          Selecting this option will cause the stack to
          print a message for each frame that is handed
          to the lowlevel driver for transmission. This
          message includes all MAC addresses and the
          frame control field.

          If unsure, say N and insert the debugging code
          you require into the driver you are debugging.

config TKIP_DEBUG
        bool "TKIP debugging"
        depends on MAC80211_DEBUG

config MAC80211_DEBUG_COUNTERS
        bool "Extra statistics for TX/RX debugging"
        depends on MAC80211_DEBUG

config MAC80211_IBSS_DEBUG
        bool "Support for IBSS testing"
        depends on MAC80211_DEBUG
        ---help---
          Say Y here if you intend to debug the IBSS code.

config MAC80211_VERBOSE_PS_DEBUG
        bool "Verbose powersave mode debugging"
        depends on MAC80211_DEBUG
        ---help---
          Say Y here to print out verbose powersave
          mode debug messages.

Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.