Subversion Repositories or1k_soc_on_altera_embedded_dev_kit

#
# Asynchronous Transfer Mode (ATM) (EXPERIMENTAL)
#

config ATM
        tristate "Asynchronous Transfer Mode (ATM) (EXPERIMENTAL)"
        depends on EXPERIMENTAL
        ---help---
          ATM is a high-speed networking technology for Local Area Networks
          and Wide Area Networks.  It uses a fixed packet size and is
          connection oriented, allowing for the negotiation of minimum
          bandwidth requirements.

          In order to participate in an ATM network, your Linux box needs an
          ATM networking card. If you have that, say Y here and to the driver
          of your ATM card below.

          Note that you need a set of user-space programs to actually make use
          of ATM.  See the file <file:Documentation/networking/atm.txt> for
          further details.

config ATM_CLIP
        tristate "Classical IP over ATM (EXPERIMENTAL)"
        depends on ATM && INET
        help
          Classical IP over ATM for PVCs and SVCs, supporting InARP and
          ATMARP. If you want to communication with other IP hosts on your ATM
          network, you will typically either say Y here or to "LAN Emulation
          (LANE)" below.

config ATM_CLIP_NO_ICMP
        bool "Do NOT send ICMP if no neighbour (EXPERIMENTAL)"
        depends on ATM_CLIP
        help
          Normally, an "ICMP host unreachable" message is sent if a neighbour
          cannot be reached because there is no VC to it in the kernel's
          ATMARP table. This may cause problems when ATMARP table entries are
          briefly removed during revalidation. If you say Y here, packets to
          such neighbours are silently discarded instead.

config ATM_LANE
        tristate "LAN Emulation (LANE) support (EXPERIMENTAL)"
        depends on ATM
        help
          LAN Emulation emulates services of existing LANs across an ATM
          network. Besides operating as a normal ATM end station client, Linux
          LANE client can also act as an proxy client bridging packets between
          ELAN and Ethernet segments. You need LANE if you want to try MPOA.

config ATM_MPOA
        tristate "Multi-Protocol Over ATM (MPOA) support (EXPERIMENTAL)"
        depends on ATM && INET && ATM_LANE!=n
        help
          Multi-Protocol Over ATM allows ATM edge devices such as routers,
          bridges and ATM attached hosts establish direct ATM VCs across
          subnetwork boundaries. These shortcut connections bypass routers
          enhancing overall network performance.

config ATM_BR2684
        tristate "RFC1483/2684 Bridged protocols"
        depends on ATM && INET
        help
          ATM PVCs can carry ethernet PDUs according to RFC2684 (formerly 1483)
          This device will act like an ethernet from the kernels point of view,
          with the traffic being carried by ATM PVCs (currently 1 PVC/device).
          This is sometimes used over DSL lines.  If in doubt, say N.

config ATM_BR2684_IPFILTER
        bool "Per-VC IP filter kludge"
        depends on ATM_BR2684
        help
          This is an experimental mechanism for users who need to terminate a
          large number of IP-only vcc's.  Do not enable this unless you are sure
          you know what you are doing.