URL
https://opencores.org/ocsvn/plasma/plasma/trunk
Subversion Repositories plasma
[/] [plasma/] [trunk/] [vhdl/] [eth_dma.vhd] - Rev 352
Go to most recent revision | Compare with Previous | Blame | View Log
--------------------------------------------------------------------- -- TITLE: Ethernet DMA -- AUTHOR: Steve Rhoads (rhoadss@yahoo.com) -- DATE CREATED: 12/27/07 -- FILENAME: eth_dma.vhd -- PROJECT: Plasma CPU core -- COPYRIGHT: Software placed into the public domain by the author. -- Software 'as is' without warranty. Author liable for nothing. -- DESCRIPTION: -- Ethernet DMA (Direct Memory Access) controller. -- Reads four bits and writes four bits from/to the Ethernet PHY each -- 2.5 MHz clock cycle. Received data is DMAed starting at 0x13ff0000 -- transmit data is read from 0x13fd0000. -- To send a packet write bytes/4 to Ethernet send register. --------------------------------------------------------------------- library ieee; use ieee.std_logic_1164.all; use ieee.std_logic_unsigned.all; use ieee.std_logic_arith.all; use work.mlite_pack.all; entity eth_dma is port( clk : in std_logic; --25 MHz reset : in std_logic; enable_eth : in std_logic; --enable receive DMA select_eth : in std_logic; rec_isr : out std_logic; --data received send_isr : out std_logic; --transmit done address : out std_logic_vector(31 downto 2); --to DDR byte_we : out std_logic_vector(3 downto 0); data_write : out std_logic_vector(31 downto 0); data_read : in std_logic_vector(31 downto 0); pause_in : in std_logic; mem_address : in std_logic_vector(31 downto 2); --from CPU mem_byte_we : in std_logic_vector(3 downto 0); data_w : in std_logic_vector(31 downto 0); pause_out : out std_logic; E_RX_CLK : in std_logic; --2.5 MHz receive E_RX_DV : in std_logic; --data valid E_RXD : in std_logic_vector(3 downto 0); --receive nibble E_TX_CLK : in std_logic; --2.5 MHz transmit E_TX_EN : out std_logic; --transmit enable E_TXD : out std_logic_vector(3 downto 0)); --transmit nibble end; --entity eth_dma architecture logic of eth_dma is signal rec_clk : std_logic_vector(1 downto 0); --receive signal rec_valid : std_logic; signal rec_latch : std_logic_vector(3 downto 0); signal rec_store : std_logic_vector(31 downto 0); --to DDR signal rec_data : std_logic_vector(27 downto 0); signal rec_cnt : std_logic_vector(2 downto 0); --nibbles signal rec_words : std_logic_vector(13 downto 0); signal rec_dma : std_logic_vector(1 downto 0); --active & request signal rec_done : std_logic; signal send_clk : std_logic_vector(1 downto 0); --transmit signal send_read : std_logic_vector(31 downto 0); --from DDR signal send_data : std_logic_vector(31 downto 0); signal send_cnt : std_logic_vector(2 downto 0); --nibbles signal send_words : std_logic_vector(8 downto 0); signal send_level : std_logic_vector(8 downto 0); signal send_dma : std_logic_vector(1 downto 0); --active & request signal send_enable: std_logic; begin --architecture dma_proc: process(clk, reset, enable_eth, select_eth, data_read, pause_in, mem_address, mem_byte_we, data_w, E_RX_CLK, E_RX_DV, E_RXD, E_TX_CLK, rec_clk, rec_valid, rec_latch, rec_store, rec_data, rec_cnt, rec_words, rec_dma, rec_done, send_clk, send_read, send_data, send_cnt, send_words, send_level, send_dma, send_enable) begin if rising_edge(E_RX_CLK) then rec_valid <= E_RX_DV; rec_latch <= E_RXD; end if; if reset = '1' then rec_clk <= "00"; rec_cnt <= "000"; rec_words <= ZERO(13 downto 0); rec_dma <= "00"; rec_done <= '0'; send_clk <= "00"; send_cnt <= "000"; send_words <= ZERO(8 downto 0); send_level <= ZERO(8 downto 0); send_dma <= "00"; send_enable <= '0'; elsif rising_edge(clk) then --Receive nibble on low->high E_RX_CLK. Send to DDR every 32 bits. rec_clk <= rec_clk(0) & E_RX_CLK; if rec_clk = "01" and enable_eth = '1' then if rec_valid = '1' or rec_cnt /= "000" then if rec_cnt = "111" then rec_store <= rec_data & rec_latch; rec_dma(0) <= '1'; --request DMA end if; rec_data <= rec_data(23 downto 0) & rec_latch; rec_cnt <= rec_cnt + 1; end if; end if; --Set transmit count or clear receive interrupt if select_eth = '1' then if mem_byte_we /= "0000" then send_cnt <= "000"; send_words <= ZERO(8 downto 0); send_level <= data_w(8 downto 0); send_dma(0) <= '1'; else rec_done <= '0'; end if; end if; --Transmit nibble on low->high E_TX_CLK. Get 32 bits from DDR. send_clk <= send_clk(0) & E_TX_CLK; if send_clk = "01" then if send_cnt = "111" then if send_words /= send_level then send_data <= send_read; send_dma(0) <= '1'; send_enable <= '1'; else send_enable <= '0'; end if; else send_data(31 downto 4) <= send_data(27 downto 0); end if; send_cnt <= send_cnt + 1; end if; --Pick which type of DMA operation: bit0 = request; bit1 = active if pause_in = '0' then if rec_dma(1) = '1' then rec_dma <= "00"; --DMA done rec_words <= rec_words + 1; if rec_valid = '0' then rec_done <= '1'; end if; elsif send_dma(1) = '1' then send_dma <= "00"; send_words <= send_words + 1; send_read <= data_read; elsif rec_dma(0) = '1' then rec_dma(1) <= '1'; --start DMA elsif send_dma(0) = '1' then send_dma(1) <= '1'; --start DMA end if; end if; end if; --rising_edge(clk) E_TXD <= send_data(31 downto 28); E_TX_EN <= send_enable; rec_isr <= rec_done; if send_words = send_level then send_isr <= '1'; else send_isr <= '0'; end if; if rec_dma(1) = '1' then address <= "0001001111111111" & rec_words; --0x13ff0000 byte_we <= "1111"; data_write <= rec_store; pause_out <= '1'; --to CPU elsif send_dma(1) = '1' then address <= "000100111111111000000" & send_words; --0x13fe0000 byte_we <= "0000"; data_write <= data_w; pause_out <= '1'; else address <= mem_address; --Send request from CPU to DDR byte_we <= mem_byte_we; data_write <= data_w; pause_out <= '0'; end if; end process; end; --architecture logic
Go to most recent revision | Compare with Previous | Blame | View Log