URL
https://opencores.org/ocsvn/rsencoder/rsencoder/trunk
Subversion Repositories rsencoder
[/] [rsencoder/] [web_uploads/] [readme.txt] - Rev 6
Compare with Previous | Blame | View Log
I/O inputs -
Inputs :
datain (8 bits) = serial input where message data is fed. If the message polynomial of form,
d_nX^n + d_(n-1)X^(n-1) + ......etc., then d_n followed by d_(n-1) in the next
clock cyle, .....etc. datain should contain a new message byte at every clock cycle
as long as the valid is high.
gin0.....gin15 (8 bits each ) = Generator polynomial co-effcients. The generator polynomial
is form X^16+gin15X^15+gin14X^14+ ......gin1X+gin0.
valid = Pull high when data becomes available. Pull low when all message bytes (total of 239
bytes) has been entered. By pulling valid low the contents of the registers are freezed.
Pull high when the next block (239 bytes) of message data is available.
clkin = input clock.
rst = reset signal to initialize registers (to all zeros).
Outputs :
q0....q15 (8 bits each) : Parity bytes in the polynomial form,
q15X^15+q14X^14+ ......q0. Latch externally if required. Valid as long
as valid signal is low.