Subversion Repositories rtcclock

///////////////////////////////////////////////////////////////////////////
//
// Filename: 	rtcdate.v
//		
// Project:	A Wishbone Controlled Real--time Clock Core
//
// Purpose:
//	This core provides a real-time date function that can be coupled with
//	a real-time clock.  The date provided is in Binary Coded Decimal (bcd)
//	form, and available for reading and writing over the Wishbone Bus.
//
// WARNING: Race conditions exist when updating the date across the Wishbone
//	bus at or near midnight.  (This should be obvious, but it bears
//	stating.)  Specifically, if the update command shows up at the same
//	clock as the ppd clock, then the ppd clock will be ignored and the 
//	new date will be the date of the day following midnight.  However,
// 	if the update command shows up one clock before the ppd, then the date
//	may be updated, but may have problems dealing with the last day of the
//	month or year.  To avoid race conditions, update the date sometime
//	after the stroke of midnight and before 5 clocks before the next
// 	midnight.  If you are concerned that you might hit a race condition, 
//	just read the clock again (5+ clocks later) to make certain you set 
//	it correctly.
//
//
// Creator:	Dan Gisselquist, Ph.D.
//		Gisselquist Technology, LLC
//
///////////////////////////////////////////////////////////////////////////
//
// Copyright (C) 2015, Gisselquist Technology, LLC
//
// This program is free software (firmware): you can redistribute it and/or
// modify it under the terms of  the GNU General Public License as published
// by the Free Software Foundation, either version 3 of the License, or (at
// your option) any later version.
//
// This program is distributed in the hope that it will be useful, but WITHOUT
// ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or
// FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License
// for more details.
//
// You should have received a copy of the GNU General Public License along
// with this program.  (It's in the $(ROOT)/doc directory.  Run make with no
// target there if the PDF file isn't present.)  If not, see
// <http://www.gnu.org/licenses/> for a copy.
//
// License:	GPL, v3, as defined and found on www.gnu.org,
//		http://www.gnu.org/licenses/gpl.html
//
//
///////////////////////////////////////////////////////////////////////////
module rtcdate(i_clk, i_ppd, i_wb_cyc, i_wb_stb, i_wb_we, i_wb_data,
		o_wb_ack, o_wb_stall, o_wb_data);
	input	i_clk;
	// A one part per day signal, i.e. basically a clock enable line that
	// controls when the beginning of the day happens.  This line should
	// be high on the very last second of any day in order for the rtcdate
	// module to always have the right date.
	input	i_ppd;
	// Wishbone inputs
	input	i_wb_cyc, i_wb_stb, i_wb_we;
	input	[31:0]	i_wb_data;
	// Wishbone outputs
	output	reg	o_wb_ack;
	output	wire	o_wb_stall;
	output	wire	[31:0]	o_wb_data;
 
 
	reg	[5:0]	r_day;
	reg	[4:0]	r_mon;
	reg	[13:0]	r_year;
 
	reg	last_day_of_month, last_day_of_year, is_leap_year;
	always @(posedge i_clk)
		last_day_of_year <= (last_day_of_month) && (r_mon == 5'h12);
	always @(posedge i_clk)
	begin
		case(r_mon)
		5'h01: last_day_of_month <= (r_day >= 6'h31); // Jan
		5'h02: last_day_of_month <= (r_day >= 6'h29)
				||((~is_leap_year)&&(r_day == 6'h28));
		5'h03: last_day_of_month <= (r_day >= 6'h31); // March
		5'h04: last_day_of_month <= (r_day >= 6'h30); // April
		5'h05: last_day_of_month <= (r_day >= 6'h31); // May
		5'h06: last_day_of_month <= (r_day >= 6'h30); // June
		5'h07: last_day_of_month <= (r_day >= 6'h31); // July
		5'h08: last_day_of_month <= (r_day >= 6'h31); // August
		5'h09: last_day_of_month <= (r_day >= 6'h30); // Sept
		5'h10: last_day_of_month <= (r_day >= 6'h31); // October
		5'h11: last_day_of_month <= (r_day >= 6'h30); // November
		5'h12: last_day_of_month <= (r_day >= 6'h31); // December
		default: last_day_of_month <= 1'b0;
		endcase
	end
 
	reg	year_divisible_by_four, century_year, four_century_year;
	always @(posedge i_clk)
		year_divisible_by_four<= ((~r_year[0])&&(r_year[4]==r_year[1]));
	always @(posedge i_clk)
		century_year <= (r_year[7:0] == 8'h00);
	always @(posedge i_clk)
		four_century_year <= ((~r_year[8])&&((r_year[12]==r_year[9])));
	always @(posedge i_clk)
		is_leap_year <= (year_divisible_by_four)&&((~century_year)
			||((century_year)&&(four_century_year)));
 
 
	// Adjust the day of month
	initial	r_day = 6'h01;
	always @(posedge i_clk)
	begin
		if ((r_day == 0)||(r_day > 6'h31)||(r_day[3:0] > 4'h9))
			r_day <= 6'h01;
		else if ((i_ppd)&&(last_day_of_month))
			r_day <= 6'h01;
		else if ((i_ppd)&&(r_day[3:0] != 4'h9))
			r_day[3:0] <= r_day[3:0] + 4'h1;
		else if (i_ppd)
		begin
			r_day[3:0] <= 4'h0;
			r_day[5:4] <= r_day[5:4] + 2'h1;
		end
 
		if ((i_wb_cyc)&&(i_wb_stb)&&(i_wb_we)&&(i_wb_data[7:0]!=8'hff))
			r_day <= i_wb_data[5:0];
	end
 
	// Adjust the month of the year
	initial	r_mon = 5'h01;
	always @(posedge i_clk)
	begin
		if ((r_mon == 0)||(r_mon > 5'h12)||(r_mon[3:0] > 4'h9))
			r_mon <= 5'h01;
		else if ((i_ppd)&&(last_day_of_year))
			r_mon <= 5'h01;
		else if ((i_ppd)&&(last_day_of_month)&&(r_mon[3:0] != 4'h9))
			r_mon[3:0] <= r_mon[3:0] + 4'h1;
		else if ((i_ppd)&&(last_day_of_month))
		begin
			r_mon[3:0] <= 4'h0;
			r_mon[4] <= 1;
		end
 
		if ((i_wb_cyc)&&(i_wb_stb)&&(i_wb_we)&&(i_wb_data[15:8]!=8'hff))
			r_mon <= i_wb_data[12:8];
	end
 
	// Adjust the year
	initial	r_year = 14'h2000;
	always @(posedge i_clk)
	begin
		// Deal with any out of bounds conditions
		if (r_year[3:0] > 4'h9)
			r_year[3:0] <= 4'h0;
		if (r_year[7:4] > 4'h9)
			r_year[7:4] <= 4'h0;
		if (r_year[11:8] > 4'h9)
			r_year[11:8] <= 4'h0;
		if ((i_ppd)&&(last_day_of_year))
		begin
			if (r_year[3:0] != 4'h9)
				r_year[3:0] <= r_year[3:0] + 4'h1;
			else begin
				r_year[3:0] <= 4'h0;
				if (r_year[7:4] != 4'h9)
					r_year[7:4] <= r_year[7:4] + 4'h1;
				else begin
					r_year[7:4] <= 4'h0;
					if (r_year[11:8] != 4'h9)
						r_year[11:8] <= r_year[11:8]+4'h1;
					else begin
						r_year[11:8] <= 4'h0;
						r_year[13:12] <= r_year[13:12]+2'h1;
					end
				end
			end
		end
 
		if ((i_wb_cyc)&&(i_wb_stb)&&(i_wb_we)&&(i_wb_data[31:16]!=16'hffff))
			r_year <= i_wb_data[29:16];
	end
 
	always @(posedge i_clk)
		o_wb_ack <= ((i_wb_cyc)&&(i_wb_stb));
	assign	o_wb_stall = 1'b0;
	assign	o_wb_data = { 2'h0, r_year, 3'h0, r_mon, 2'h0, r_day };
endmodule