Subversion Repositories socgen

//////////////////////////////////////////////////////////////////////
////                                                              ////
////  uart_defines.v                                              ////
////                                                              ////
////                                                              ////
////  This file is part of the "UART 16550 compatible" project    ////
////  http://www.opencores.org/cores/uart16550/                   ////
////                                                              ////
////  Documentation related to this project:                      ////
////  - http://www.opencores.org/cores/uart16550/                 ////
////                                                              ////
////  Projects compatibility:                                     ////
////  - WISHBONE                                                  ////
////  RS232 Protocol                                              ////
////  16550D uart (mostly supported)                              ////
////                                                              ////
////  Overview (main Features):                                   ////
////  Defines of the Core                                         ////
////                                                              ////
////  Known problems (limits):                                    ////
////  None                                                        ////
////                                                              ////
////  To Do:                                                      ////
////  Nothing.                                                    ////
////                                                              ////
////  Author(s):                                                  ////
////      - gorban@opencores.org                                  ////
////      - Jacob Gorban                                          ////
////      - Igor Mohor (igorm@opencores.org)                      ////
////                                                              ////
////  Created:        2001/05/12                                  ////
////  Last Updated:   2001/05/17                                  ////
////                  (See log for the revision history)          ////
////                                                              ////
////                                                              ////
//////////////////////////////////////////////////////////////////////
////                                                              ////
//// Copyright (C) 2000, 2001 Authors                             ////
////                                                              ////
//// This source file may be used and distributed without         ////
//// restriction provided that this copyright statement is not    ////
//// removed from the file and that any derivative work contains  ////
//// the original copyright notice and the associated disclaimer. ////
////                                                              ////
//// This source file is free software; you can redistribute it   ////
//// and/or modify it under the terms of the GNU Lesser General   ////
//// Public License as published by the Free Software Foundation; ////
//// either version 2.1 of the License, or (at your option) any   ////
//// later version.                                               ////
////                                                              ////
//// This source is distributed in the hope that it will be       ////
//// useful, but WITHOUT ANY WARRANTY; without even the implied   ////
//// warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR      ////
//// PURPOSE.  See the GNU Lesser General Public License for more ////
//// details.                                                     ////
////                                                              ////
//// You should have received a copy of the GNU Lesser General    ////
//// Public License along with this source; if not, download it   ////
//// from http://www.opencores.org/lgpl.shtml                     ////
////                                                              ////
//////////////////////////////////////////////////////////////////////

// 2011/10/01  Split into 8 bit and 32 bit versions
//             always provide baudrate output enable
//             converted PRESCALER_PRESET from `define to parameter
//             Removed unused `defines, added back LITTLE_ENDIAN
//             Removed all # delays for non-blocking statement
//             Changed all module names to start with `VARIANT
//             Converted reset from async to sync
//             jt_eaton
//
// CVS Revision History
//
// $Log: not supported by cvs2svn $
// Revision 1.13  2003/06/11 16:37:47  gorban
// This fixes errors in some cases when data is being read and put to the FIFO at the same time. Patch is submitted by Scott Furman. Update is very recommended.
//
// Revision 1.12  2002/07/22 23:02:23  gorban
// Bug Fixes:
//  * Possible loss of sync and bad reception of stop bit on slow baud rates fixed.
//   Problem reported by Kenny.Tung.
//  * Bad (or lack of ) loopback handling fixed. Reported by Cherry Withers.
//
// Improvements:
//  * Made FIFO's as general inferrable memory where possible.
//  So on FPGA they should be inferred as RAM (Distributed RAM on Xilinx).
//  This saves about 1/3 of the Slice count and reduces P&R and synthesis times.
//
//
// Revision 1.10  2001/12/11 08:55:40  mohor
// Scratch register define added.
//
// Revision 1.9  2001/12/03 21:44:29  gorban
// Updated specification documentation.
// Added full 32-bit data bus interface, now as default.
// Address is 5-bit wide in 32-bit data bus mode.
// Added wb_sel_i input to the core. It's used in the 32-bit mode.
// Added debug interface with two 32-bit read-only registers in 32-bit mode.
// Bits 5 and 6 of LSR are now only cleared on TX FIFO write.
// My small test bench is modified to work with 32-bit mode.
//
// Revision 1.8  2001/11/26 21:38:54  gorban
// Lots of fixes:
// Break condition wasn't handled correctly at all.
// LSR bits could lose their values.
// LSR value after reset was wrong.
// Timing of THRE interrupt signal corrected.
// LSR bit 0 timing corrected.
//
// Revision 1.7  2001/08/24 21:01:12  mohor
// Things connected to parity changed.
// Clock devider changed.
//
// Revision 1.6  2001/08/23 16:05:05  mohor
// Stop bit bug fixed.
// Parity bug fixed.
// WISHBONE read cycle bug fixed,
// OE indicator (Overrun Error) bug fixed.
// PE indicator (Parity Error) bug fixed.
// Register read bug fixed.
//
// Revision 1.5  2001/05/31 20:08:01  gorban
// FIFO changes and other corrections.
//
// Revision 1.4  2001/05/21 19:12:02  gorban
// Corrected some Linter messages.
//
// Revision 1.3  2001/05/17 18:34:18  gorban
// First 'stable' release. Should be sythesizable now. Also added new header.
//
// Revision 1.0  2001-05-17 21:27:11+02  jacob
// Initial revision
//
//


// Interrupt Enable register bits
`define UART_IE_RDA     0        // Received Data available interrupt
`define UART_IE_THRE    1       // Transmitter Holding Register empty interrupt
`define UART_IE_RLS     2       // Receiver Line Status Interrupt
`define UART_IE_MS      3       // Modem Status Interrupt

// Interrupt Identification register bits
`define UART_II_IP      0        // Interrupt pending when 0
`define UART_II_II      3:1     // Interrupt identification

// Interrupt identification values for bits 3:1
`define UART_II_RLS     3'b011  // Receiver Line Status
`define UART_II_RDA     3'b010  // Receiver Data available
`define UART_II_TI      3'b110  // Timeout Indication
`define UART_II_THRE    3'b001  // Transmitter Holding Register empty
`define UART_II_MS      3'b000  // Modem Status

// FIFO Control Register bits
`define UART_FC_TL      7:6     // Trigger level

// FIFO trigger level values
`define UART_FC_1               2'b00
`define UART_FC_4               2'b01
`define UART_FC_8               2'b10
`define UART_FC_14              2'b11

// Line Control register bits
`define UART_LC_BITS    1:0     // bits in character
`define UART_LC_SB      2       // stop bits
`define UART_LC_PE      3       // parity enable
`define UART_LC_EP      4       // even parity
`define UART_LC_SP      5       // stick parity
`define UART_LC_BC      6       // Break control
`define UART_LC_DL      7       // Divisor Latch access bit

// Modem Control register bits
`define UART_MC_DTR     0
`define UART_MC_RTS     1
`define UART_MC_OUT1    2
`define UART_MC_OUT2    3
`define UART_MC_LB      4       // Loopback mode

// Line Status Register bits
`define UART_LS_DR      0        // Data ready
`define UART_LS_OE      1       // Overrun Error
`define UART_LS_PE      2       // Parity Error
`define UART_LS_FE      3       // Framing Error
`define UART_LS_BI      4       // Break interrupt
`define UART_LS_TFE     5       // Transmit FIFO is empty
`define UART_LS_TE      6       // Transmitter Empty indicator
`define UART_LS_EI      7       // Error indicator

// Modem Status Register bits
`define UART_MS_DCTS    0        // Delta signals
`define UART_MS_DDSR    1
`define UART_MS_TERI    2
`define UART_MS_DDCD    3
`define UART_MS_CCTS    4       // Complement signals
`define UART_MS_CDSR    5
`define UART_MS_CRI     6
`define UART_MS_CDCD    7

// FIFO parameter defines

`define UART_FIFO_WIDTH 8
`define UART_FIFO_DEPTH 16
`define UART_FIFO_POINTER_W     4
`define UART_FIFO_COUNTER_W     5
// receiver fifo has width 11 because it has break, parity and framing error bits
`define UART_FIFO_REC_WIDTH  11




// Defines hard baud prescaler register - uncomment to enable
//`define PRESCALER_PRESET_HARD
// 115200 baud preset values
// 20MHz: prescaler 10.8 (11, rounded up)
//`define PRESCALER_HIGH_PRESET 8'd0
//`define PRESCALER_LOW_PRESET 8'd11
// 50MHz: prescaler 27.1
//`define PRESCALER_HIGH_PRESET 8'd0
//`define PRESCALER_LOW_PRESET 8'd27