OpenCores
URL https://opencores.org/ocsvn/tv80/tv80/trunk

Subversion Repositories tv80

[/] [tv80/] [trunk/] [tests/] [ivec_flags.ast] - Rev 116

Go to most recent revision | Compare with Previous | Blame | View Log

; test of interrupt vector flags
;
; initializes a memory region and then transfers that region
; to an accumulator

    .module otir

;--------------------------------------------------------
; special function registers
;--------------------------------------------------------
_sim_ctl_port   =       0x0080
_msg_port       =       0x0081
_timeout_port   =       0x0082
_max_timeout_low        =       0x0083
_max_timeout_high       =       0x0084
_intr_cntdwn    =       0x0090
_cksum_value    =       0x0091
_cksum_accum    =       0x0092
_inc_on_read    =       0x0093

    .area INIT (ABS)
    .org  0

    jp      init


init:
    ld      sp, #0xffff

    ;--------------------------------------------------
    ; test S flag

    ; test for s set on negative values
    ld      a, #0xff
    ld      i, a
    ld      a, i   ; S should be set
    jp      p, test_fail

    ld      a, #0xff
    ld      r, a
    ld      a, r   ; S should be set
    jp      p, test_fail

    ; test for s clear on positive values
    ld      a, #0x20
    ld      i, a
    ld      a, i   ; S should be clear
    jp      m, test_fail

    ; test for s clear on positive values
    ld      a, #0x20
    ld      r, a
    ld      a, r   ; S should be clear
    jp      m, test_fail

    
    ;--------------------------------------------------
    ; test Z flag

    ; test for z set on zero values
    ld      a, #0
    ld      i, a
    ld      a, i   ; S should be set
    jp      nz, test_fail

    ld      a, #0
    ld      r, a
    ld      a, r   ; S should be set
    jp      nz, test_fail

    ; test for s clear on positive values
    ld      a, #0x20
    ld      i, a
    ld      a, i   ; S should be clear
    jp      z, test_fail

    ; test for s clear on positive values
    ld      a, #0x20
    ld      r, a
    ld      a, r   ; S should be clear
    jp      z, test_fail

    ;--------------------------------------------------
    ; test H flag

    ; by spec the H flag is not in the flags register,
    ; so this bit is difficult to test
    
    ;--------------------------------------------------
    ; test P/V flag

    ; TBD

    ;--------------------------------------------------
    ; test N flag

    neg               ; sets the N flag
    ld      a, i      ; clears N flag
    push    af
    pop     bc        ; N should be bit 4 of C
    ld      a, c
    and     #0x10
    jp      nz, test_fail

    neg               ; sets the N flag
    ld      a, r      ; clears N flag
    push    af
    pop     bc        ; N should be bit 4 of C
    ld      a, c
    and     #0x10
    jp      nz, test_fail

    ;--------------------------------------------------
    ; test C flag
    ; should not be affected by this op

    scf
    ld      a, i
    ld      a, r
    jp      nc, test_fail

    ccf
    ld      a, i
    ld      a, r
    jp      c, test_fail

test_pass:
    ;; finish simulation with test passed
    ld      a, #1
    out     (_sim_ctl_port), a
    halt

test_fail:
    ld      a, #2
    out     (_sim_ctl_port), a
    ret

reset_timeout:
    ld      a, #2
    out     (_timeout_port), a
    ret
    
    .org    0x8000

dbuf:
    .ds     256

Go to most recent revision | Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.