OpenCores
URL https://opencores.org/ocsvn/uart_block/uart_block/trunk

Subversion Repositories uart_block

[/] [uart_block/] [trunk/] [hdl/] [iseProject/] [serial_transmitter.vhd] - Rev 11

Go to most recent revision | Compare with Previous | Blame | View Log

--! Data transmitter
--! http://www.fpga4fun.com/SerialInterface.html
library IEEE;
use IEEE.STD_LOGIC_1164.ALL;
 
--! Use CPU Definitions package
use work.pkgDefinitions.all;
 
entity serial_transmitter is
    Port ( rst : in  STD_LOGIC;
           baudClk : in  STD_LOGIC;
           data_byte : in  STD_LOGIC_VECTOR ((nBits-1) downto 0);
			  data_sent : out STD_LOGIC;
           serial_out : out  STD_LOGIC);
end serial_transmitter;
 
architecture Behavioral of serial_transmitter is
signal current_s,next_s: txStates; 
begin
 
	-- Next state process
	process (rst, baudClk) 
	begin
		if rst = '1' then
			current_s <= tx_idle;
		elsif rising_edge(baudClk) then
			current_s <= next_s;
		end if;
	end process;
 
	process (current_s, data_byte)
	begin
		case current_s is
			when tx_idle =>
				serial_out <= '1';
				data_sent <= '0';
				next_s <= tx_start;
 
			-- Start bit
			when tx_start =>
				serial_out <= '0';
				data_sent <= '0';
				next_s <= bit0;
 
			when bit0 =>	-- Send the least significat bit
				serial_out <= data_byte(0);
				data_sent <= '0';
				next_s <= bit1;
 
			when bit1 =>
				serial_out <= data_byte(1);
				data_sent <= '0';
				next_s <= bit2;
 
			when bit2 =>
				serial_out <= data_byte(2);
				data_sent <= '0';
				next_s <= bit3;
 
			when bit3 =>
				serial_out <= data_byte(3);
				data_sent <= '0';
				next_s <= bit4;
 
			when bit4 =>
				serial_out <= data_byte(4);
				data_sent <= '0';
				next_s <= bit5;
 
			when bit5 =>
				serial_out <= data_byte(5);
				data_sent <= '0';
				next_s <= bit6;
 
			when bit6 =>
				serial_out <= data_byte(6);
				data_sent <= '0';
				next_s <= bit7;
 
			when bit7 =>	-- Send the most significat bit
				serial_out <= data_byte(7);
				data_sent <= '0';
				next_s <= tx_stop1;
 
 
			when tx_stop1 =>
				serial_out <= '1';
				data_sent <= '1';
				next_s <= tx_stop2;
 
			when tx_stop2 =>	-- Stop here and wait for other reset
				serial_out <= '1';
				data_sent <= '1';
				next_s <= tx_stop2;
 
		end case;
	end process;
 
end Behavioral;
 
 

Go to most recent revision | Compare with Previous | Blame | View Log

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.