URL
https://opencores.org/ocsvn/xulalx25soc/xulalx25soc/trunk
Subversion Repositories xulalx25soc
[/] [xulalx25soc/] [trunk/] [rtl/] [wbutohex.v] - Rev 21
Go to most recent revision | Compare with Previous | Blame | View Log
/////////////////////////////////////////////////////////////////////////// // // Filename: wbutohex.v // // Project: XuLA2 board // // Purpose: Supports a printable character conversion from a printable // ASCII character to six bits of valid data. The encoding is // as follows: // // 0-9 -> 0-9 // A-Z -> 10-35 // a-z -> 36-61 // @ -> 62 // % -> 63 // // Note that decoding is stateless, yet requires one clock. // // Creator: Dan Gisselquist, Ph.D. // Gisselquist Technology, LLC // /////////////////////////////////////////////////////////////////////////// // // Copyright (C) 2015, Gisselquist Technology, LLC // // This program is free software (firmware): you can redistribute it and/or // modify it under the terms of the GNU General Public License as published // by the Free Software Foundation, either version 3 of the License, or (at // your option) any later version. // // This program is distributed in the hope that it will be useful, but WITHOUT // ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or // FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License // for more details. // // License: GPL, v3, as defined and found on www.gnu.org, // http://www.gnu.org/licenses/gpl.html // // /////////////////////////////////////////////////////////////////////////// // // // // // Copyright: 2015 // // module wbutohex(i_clk, i_stb, i_byte, o_stb, o_valid, o_hexbits); input i_clk, i_stb; input [7:0] i_byte; output reg o_stb, o_valid; output reg [5:0] o_hexbits; always @(posedge i_clk) o_stb <= i_stb; always @(posedge i_clk) begin // These are the defaults, to be overwridden by the ifs below o_valid <= 1'b1; o_hexbits <= 6'h00; if ((i_byte >= 8'h30)&&(i_byte <= 8'h39)) // A digit o_hexbits <= { 2'b0, i_byte[3:0] }; else if ((i_byte >= 8'h41)&&(i_byte <= 8'h5a)) // Upper case o_hexbits <= (i_byte[5:0] - 6'h01 + 6'h0a);// -'A'+10 else if ((i_byte >= 8'h61)&&(i_byte <= 8'h7a)) o_hexbits <= (i_byte[5:0] +6'h03); // -'a'+(10+26) else if (i_byte == 8'h40) // An '@' sign o_hexbits <= 6'h3e; else if (i_byte == 8'h25) // A '%' sign o_hexbits <= 6'h3f; else o_valid <= 1'b0; end endmodule
Go to most recent revision | Compare with Previous | Blame | View Log