URL
https://opencores.org/ocsvn/zipcpu/zipcpu/trunk
Subversion Repositories zipcpu
[/] [zipcpu/] [trunk/] [rtl/] [peripherals/] [flashcache.v] - Rev 64
Go to most recent revision | Compare with Previous | Blame | View Log
/////////////////////////////////////////////////////////////////////////// // // Filename: flashcache.v // // Project: Zip CPU -- a small, lightweight, RISC CPU soft core // // Purpose: Since my Zip CPU has primary access to a flash, which requires // nearly 24 clock cycles per read, this 'cache' module // is offered to minimize the effect. The CPU may now request // some amount of flash to be copied into this on-chip RAM, // and then access it with nearly zero latency. // // Interface: // FlashCache sits on the Wishbone bus as both a slave and a master. // Slave requests for memory will get mapped to a local RAM, from which // reads and writes may take place. // // This cache supports a single control register: the base wishbone address // of the device to copy memory from. The bottom bit if this address must // be zero (or it will be silently rendered as zero). When read, this // bottom bit will indicate 1) that the controller is still loading memory // into the cache, or 0) that the cache is ready to be used. // // Writing to this register will initiate a memory copy from the (new) // address. Once done, the loading bit will be cleared and an interrupt // generated. // // Where this memory is placed on the wishbone bus is entirely up to the // wishbone bus control logic. Setting the memory base to an // address controlled by this flashcache will produce unusable // results, and may well hang the bus. // Reads from the memory before complete will return immediately with // the value if read address is less than the current copy // address, or else they will stall until the read address is // less than the copy address. // // Creator: Dan Gisselquist, Ph.D. // Gisselquist Tecnology, LLC // /////////////////////////////////////////////////////////////////////////// // // Copyright (C) 2015, Gisselquist Technology, LLC // // This program is free software (firmware): you can redistribute it and/or // modify it under the terms of the GNU General Public License as published // by the Free Software Foundation, either version 3 of the License, or (at // your option) any later version. // // This program is distributed in the hope that it will be useful, but WITHOUT // ANY WARRANTY; without even the implied warranty of MERCHANTIBILITY or // FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License // for more details. // // License: GPL, v3, as defined and found on www.gnu.org, // http://www.gnu.org/licenses/gpl.html // // /////////////////////////////////////////////////////////////////////////// // module flashcache(i_clk, // Wishbone contrl interface i_wb_cyc, i_wb_stb,i_wb_ctrl_stb, i_wb_we, i_wb_addr, i_wb_data, o_wb_ack, o_wb_stall, o_wb_data, // Wishbone copy interface o_cp_cyc, o_cp_stb, o_cp_we, o_cp_addr, o_cp_data, i_cp_ack, i_cp_stall, i_cp_data, o_int); parameter LGCACHELEN=10; // 4 kB input i_clk; // Control interface, CPU interface to cache input i_wb_cyc, i_wb_stb,i_wb_ctrl_stb, i_wb_we; input [(LGCACHELEN-1):0] i_wb_addr; input [31:0] i_wb_data; output reg o_wb_ack; output wire o_wb_stall; output wire [31:0] o_wb_data; // Interface to peripheral bus, including flash output reg o_cp_cyc, o_cp_stb; output wire o_cp_we; output reg [31:0] o_cp_addr; output wire [31:0] o_cp_data; input i_cp_ack, i_cp_stall; input [31:0] i_cp_data; // And an interrupt to send once we complete output reg o_int; reg loading; reg [31:0] cache_base; reg [31:0] cache [0:((1<<LGCACHELEN)-1)]; // Decouple writing the cache base from the highly delayed bus lines reg wr_cache_base_flag; reg [31:0] wr_cache_base_value; always @(posedge i_clk) wr_cache_base_flag <= ((i_wb_cyc)&&(i_wb_ctrl_stb)&&(i_wb_we)); always @(posedge i_clk) wr_cache_base_value<= { i_wb_data[31:1], 1'b0 }; initial cache_base = 32'hffffffff; always @(posedge i_clk) if (wr_cache_base_flag) cache_base <= wr_cache_base_value; reg new_cache_base; initial new_cache_base = 1'b0; always @(posedge i_clk) if ((wr_cache_base_flag)&&(cache_base != wr_cache_base_value)) new_cache_base <= 1'b1; else new_cache_base <= 1'b0; reg [(LGCACHELEN-1):0] rdaddr; initial loading = 1'b0; always @(posedge i_clk) if (new_cache_base) begin loading <= 1'b1; o_cp_cyc <= 1'b0; end else if ((~o_cp_cyc)&&(loading)) begin o_cp_cyc <= 1'b1; end else if (o_cp_cyc) begin // Handle the ack/read line if (i_cp_ack) begin if (&rdaddr) begin o_cp_cyc <= 1'b0; loading <= 1'b0; end end end always @(posedge i_clk) if (~o_cp_cyc) o_cp_addr <= cache_base; else if ((o_cp_cyc)&&(o_cp_stb)&&(~i_cp_stall)) o_cp_addr <= o_cp_addr + 1;; always @(posedge i_clk) if ((~o_cp_cyc)&&(loading)) o_cp_stb <= 1'b1; else if ((o_cp_cyc)&&(o_cp_stb)&&(~i_cp_stall)) begin // We've made our last request if (o_cp_addr >= cache_base + { {(32-LGCACHELEN-1){1'b0}}, 1'b1, {(LGCACHELEN){1'b0}}}) o_cp_stb <= 1'b0; end always @(posedge i_clk) if (~loading) rdaddr <= 0; else if ((o_cp_cyc)&&(i_cp_ack)) rdaddr <= rdaddr + 1; initial o_int = 1'b0; always @(posedge i_clk) if ((o_cp_cyc)&&(i_cp_ack)&&(&rdaddr)) o_int <= 1'b1; else o_int <= 1'b0; assign o_cp_we = 1'b0; assign o_cp_data = 32'h00; // // Writes to our cache ... always delayed by a clock. // Clock 0 : Write request // Clock 1 : Write takes place // Clock 2 : Available for reading // reg we; reg [(LGCACHELEN-1):0] waddr; reg [31:0] wval; always @(posedge i_clk) we <= (loading)?((o_cp_cyc)&&(i_cp_ack)):(i_wb_cyc)&&(i_wb_stb)&&(i_wb_we); always @(posedge i_clk) waddr <= (loading)?rdaddr:i_wb_addr; always @(posedge i_clk) wval <= (loading)?i_cp_data:i_wb_data; always @(posedge i_clk) if (we) cache[waddr] <= wval; reg [31:0] cache_data; always @(posedge i_clk) if ((i_wb_cyc)&&(i_wb_stb)) cache_data <= cache[i_wb_addr]; always @(posedge i_clk) o_wb_ack <= (i_wb_cyc)&&( ((i_wb_stb)&&(~loading)) ||(i_wb_ctrl_stb)); reg ctrl; always @(posedge i_clk) ctrl <= i_wb_ctrl_stb; assign o_wb_data = (ctrl)?({cache_base[31:1],loading}):cache_data; assign o_wb_stall = (loading)&&(~o_wb_ack); endmodule
Go to most recent revision | Compare with Previous | Blame | View Log