OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk] - Rev 285

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
285 Binary operator used instead of unary (xnor). mohor 7681d 19h /ethmac/trunk
284 Busy was set 2 cycles too late. Reported by Dennis Scott. mohor 7709d 20h /ethmac/trunk
283 RxBDAddress was updated also when value to r_TxBDNum was written with
greater value than allowed.
mohor 7737d 13h /ethmac/trunk
281 Tests test_mac_full_duplex_receive 4-7 fixed to proper BD. mohor 7814d 14h /ethmac/trunk
280 Reset has priority in some flipflops. mohor 7815d 15h /ethmac/trunk
279 Underrun test fixed. Many other tests fixed. mohor 7815d 16h /ethmac/trunk
278 A new bug (entered with previous update) fixed. When abort occured sometimes
data transmission was blocked.
mohor 7815d 16h /ethmac/trunk
277 When padding was enabled and crc disabled, frame was not ended correctly. mohor 7815d 16h /ethmac/trunk
276 Defer indication changed. tadejm 7815d 16h /ethmac/trunk
275 Fix MTxErr or prevent sending too big frames. mohor 7822d 21h /ethmac/trunk
274 Backup version. Not fully working. tadejm 7823d 10h /ethmac/trunk
272 When control packets were received, they were ignored in some cases. tadejm 7823d 16h /ethmac/trunk
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.
mohor 7824d 18h /ethmac/trunk
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7825d 18h /ethmac/trunk
268 Release 1.19. Control frame description changed. mohor 7879d 11h /ethmac/trunk
267 Full duplex control frames tested. mohor 7879d 14h /ethmac/trunk
266 Flow control test almost finished. mohor 7884d 12h /ethmac/trunk
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7884d 16h /ethmac/trunk
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 7885d 04h /ethmac/trunk
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 7885d 04h /ethmac/trunk
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.
mohor 7885d 04h /ethmac/trunk
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.
mohor 7885d 16h /ethmac/trunk
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7886d 05h /ethmac/trunk
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7886d 06h /ethmac/trunk
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7886d 06h /ethmac/trunk
255 TPauseRq synchronized to tx_clk. mohor 7886d 06h /ethmac/trunk
254 Temp version. mohor 7887d 09h /ethmac/trunk
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7887d 12h /ethmac/trunk
252 Just some updates. tadejm 7887d 12h /ethmac/trunk
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7887d 12h /ethmac/trunk

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.