Rev |
Log message |
Author |
Age |
Path |
1392 |
Make uart use the new trace functions |
nogj |
7037d 02h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1390 |
* Change scheduler to count down to 0 instead of reaching a certain cycle
count.
* Change the SCHED_ADD interface to take a time out as the parameter instead of the number of cycles. |
nogj |
7037d 02h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1367 |
Cleanup uart peripheral useing the new callback mechanism |
nogj |
7077d 21h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1366 |
Pass a caller given pointer to the vapi_read callback |
nogj |
7077d 21h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1359 |
Pass private data in readfunc/writefunc callbacks |
nogj |
7077d 21h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1358 |
Modularise config file parseing. Paving the way for further modularisation. |
nogj |
7077d 21h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1350 |
Mark a simulated cpu address as such, by introducing the new oraddr_t type |
nogj |
7087d 00h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1308 |
Gyorgy Jeney: extensive cleanup |
phoenix |
7291d 19h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1244 |
Added "cm" command to copy data inside memory.
Make or1ksim work on little endian platforms.
Port to Mac OS X.
Some bugfixes.
Allow JTAG write access to read-only memory regions. |
hpanther |
7459d 03h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1165 |
timeout bug fixed; contribution by Carlos |
markom |
7698d 02h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1153 |
When multiple interrupts were pending, e.g. TX buffer empty and RX
available, reading the UART's IIR register could potentially clear a
TX interrupt before it had been sent to the processor, thus dropping
the interrupt permanently.
Fix tested w/ both eCos and uclinux. |
sfurman |
7755d 22h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1145 |
1) Fix trivial bug w/ transmitter empty interrupts that I introduced in the
last check-in.
2) Improve printed output from debugging-only uart_status() routine. |
sfurman |
7756d 15h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1143 |
Make UART transmitter-empty interrupts match both 16450 and 16550 behavior. |
sfurman |
7759d 12h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1116 |
There was a bug in the simulator's UART implementation that caused the
UART's LSR register to become corrupted. This was due to an
assumption that 'char' is an unsigned type, but that is not true on
all platforms.
When the char type is signed and a character is read in the range
0x80-0xff, the high bit is sign-extended into the upper bits of an
entry in the receive FIFO. When the character reaches the head of the
FIFO, the upper bits of the FIFO entry are OR'ed into the LSR, causing
the LSR to be set to 0xFF.
A simple cast fixes the problem. |
sfurman |
7799d 20h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
1073 |
channels support |
rprescott |
7925d 00h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
997 |
PRINTF should be used instead of printf; command redirection repaired |
markom |
7988d 09h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
970 |
Testbench is now running on ORP architecture platform. |
simons |
7995d 20h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
884 |
code cleaning - a lot of global variables moved to runtime struct |
markom |
8032d 07h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
821 |
ugly bug with duplicate redefined i removed |
markom |
8118d 04h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
806 |
uart now partially uses scheduler |
markom |
8123d 10h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
805 |
kbd, fb, vga devices now uses scheduler |
markom |
8123d 11h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
713 |
lot of small minor improvements: code documented, cleaned; runs at about same speed when not actually logging, but exe_log is enabled; raw_stats now run only with simple execution - enable RAW_USAGE_STATS macro |
markom |
8160d 09h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
549 |
enabled parameters removed from devices, which also have number of devices; command line --output-cfg parameter added |
markom |
8214d 05h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
530 |
THRI interrupt fixed. |
simons |
8216d 22h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
529 |
Bug in receiver fixed. |
simons |
8217d 00h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
492 |
uart THRE interrupt immedialty after write to IER |
markom |
8233d 08h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
490 |
clkcycle parsing problem fixed |
markom |
8234d 03h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
424 |
memory configuration file joined into .cfg file; *mem.cfg are obsolete; read-only and write-only memory is supported; memory logging is not yet supported; update of testbench - only cache test fails, since it writes to RO memory |
markom |
8243d 07h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
423 |
changed break behaviour and interrupt pending; interrupt line chabnged to 15; sync bug in mode switch |
markom |
8244d 03h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |
411 |
acv uart testsuite now works (without modem test) |
markom |
8247d 08h |
/or1k/tags/nog_patch_47/or1ksim/peripheral/16450.c |