Rev |
Log message |
Author |
Age |
Path |
82 |
|
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
81 |
Adds register values for the SD-Card registers. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
80 |
Currently working version: contains both a working DMA controller as well as
a working (as far as I can tell) SD-Card controller (writes not yet tested). |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
79 |
Adds 'bench' and 'sw' targets, and automatically builds them (now). |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
78 |
Comments out the line that caused a compiler warning--setting an unused
variable. Code should be better as a result. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
77 |
Adds register names and values for the SD card interface. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
76 |
Now tries to avoid reading from the stack if the stack addresses are already
known to be bad. That way, the debugger tries to preserve any bus error address
already on the buserr device. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
75 |
Added simulation capability for the SD-Card, as well as debugging output for the
DMA. (The SD-Card debug may not be fully featured, yet, but it has gotten me
to where I can talk to the card.) |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
74 |
Adds the SD-card capability, and connects the debug wires to/from the uartdev
in case it needs to be debugged. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
73 |
Simplified logic. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
72 |
Sets XULA25 as the default. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
71 |
Needed to play with subtle timing to get this to build. Expect me to play
with these two clock numbers more. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
70 |
Cosmetic (minor) update. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
69 |
Massive logic simplification. This is also the first (verified) working
version. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
68 |
Fixes the debug ack line, so it no longer acks when there isn't a dbg_stb.
Fixed the multiply option parameter, so it sets a 3-clock multiply properly.
Adjusted the watchdog timer so that it now produces a timer that doesn't
reload--since this is pointless for a watchdog. Finally, connects a reset
line to the DMA, to make certain that resetting the CPU will also reset any
ongoing DMA operation. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
67 |
Simplifies logic, and guarantees that the minimum set value will always
produce an int. For example, if the count was X before, setting X-1 wouldn't
produce an interrupt since it had passed. Now it produces an interrupt, and
keeps the next interrupt valid. |
dgisselq |
2984d 12h |
/xulalx25soc/trunk |
66 |
Simplified logic (barely). |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
65 |
Makes the auto-reload feature a parameterized (generic) feature, so the same
code will work for both auto-reloadable and non-autoreloadable (i.e. watchdog)
timers. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
64 |
First (verified) working version. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
63 |
Simplified logic. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
62 |
Removed the pipe logic from the non-pipelined version, and made the NOOP a
specific ALU instruction so that the PC is always properly updated. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
61 |
Fixed the timing control wires: busy and valid will never both be true. Busy
will be true (now) until valid is asserted, and busy will never not be
asserted until valid is true. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
60 |
LONG_MPY upgrade. This is part of swapping out the LDIHI instruction for a
MPY, and the MPYS and MPYU instructions for MPYSHI and MPYUHI respectively. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
59 |
Simplified logic. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
58 |
Bug fix: the UART can now be reconfigured post-boot without a BREAK condition. |
dgisselq |
2984d 13h |
/xulalx25soc/trunk |
57 |
Fixed the TX/RX addresses so that they match the documentation: TX first, then
RX. |
dgisselq |
2992d 12h |
/xulalx25soc/trunk |
56 |
Brings code in line with the OpenCores core: parameterizes the reload value,
and the number of bits in the timer. |
dgisselq |
2992d 12h |
/xulalx25soc/trunk |
55 |
Updated copyright notice. |
dgisselq |
2992d 12h |
/xulalx25soc/trunk |
54 |
Updated copyright notice. |
dgisselq |
2992d 12h |
/xulalx25soc/trunk |
53 |
Added a touch of error checking. |
dgisselq |
3032d 13h |
/xulalx25soc/trunk |