OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] - Rev 67

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
67 renamed boot-loader.c to boot-loader-serial.c csantifort 4078d 21h /
66 Remove the stand-alone ethmac test. Use boot-loader-ethmac instead to verify ethmac functionality. csantifort 4078d 22h /
65 Renamed boot-loader to boot-loader-serial csantifort 4078d 22h /
64 Support latest Xilinx ISE 14.5 software. csantifort 4078d 22h /
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.		 csantifort 4079d 02h /
62 Added source for amber-pkt2mem csantifort 4231d 15h /
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.		 csantifort 4365d 21h /
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4583d 17h /
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4653d 14h /
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4653d 18h /
57 Add some debug messages csantifort 4653d 18h /
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.		 csantifort 4653d 18h /
55 Added sudo to rm mnt command csantifort 4653d 18h /
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.		 csantifort 4670d 17h /
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4685d 15h /
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4685d 15h /
51 Revert vmlinux back to 48. csantifort 4726d 15h /
50 Revert to previous version csantifort 4726d 15h /
49 Added a note n how to change timeouts csantifort 4726d 15h /
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.		 csantifort 4730d 22h /
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4750d 19h /
46 svn ignore vmlinux.dis and vmlinux.mem csantifort 4758d 17h /
45 Store vmlinux.mem and vmlinux.dis in compressed form csantifort 4758d 17h /
44 Updated vmlinux image based on last change csantifort 4758d 17h /
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.		 csantifort 4758d 17h /
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4776d 14h /
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 4777d 22h /
40 Added wishbone bus jitter testing option.
Cleaned up waveform log .do files, now seperate files for a23 and a25 cores.
Added vmlinux executable elf file for running on hardware.		 csantifort 4782d 15h /
39 Added a second level of buffering to a25_wishbone_buf to fix a lockup
bug when write acks to not return immediately, and also to improve performance slightly		 csantifort 4783d 16h /
38 support 128-bit wishbone now used for a25 core csantifort 4784d 15h /

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.