Rev |
Log message |
Author |
Age |
Path |
220 |
More revision sections added |
jshamlet |
1534d 12h |
/open8_urisc/ |
219 |
Added revision block and corrected creation date. |
jshamlet |
1534d 12h |
/open8_urisc/ |
218 |
Revision sections added,
vdsm8.vhd added. |
jshamlet |
1534d 12h |
/open8_urisc/ |
217 |
Broke out the vdsm8 as a separate entity, since it is used in several places,
Even MORE code cleanup. |
jshamlet |
1534d 12h |
/open8_urisc/ |
216 |
Fixed missing parenthesis |
jshamlet |
1534d 14h |
/open8_urisc/ |
215 |
More code cleanup |
jshamlet |
1534d 15h |
/open8_urisc/ |
214 |
Initial add of some older code |
jshamlet |
1538d 13h |
/open8_urisc/ |
213 |
Code and comment cleanup |
jshamlet |
1538d 13h |
/open8_urisc/ |
212 |
Fixed issue with rewritten epoch timer not clearing alarm on set point write. |
jshamlet |
1538d 19h |
/open8_urisc/ |
211 |
Ok, this time with feeling. Timer should now properly reset on interval update. |
jshamlet |
1539d 17h |
/open8_urisc/ |
210 |
Modified the timers to reset on new interval write. This avoids an issue in the original design where the timer had to reach zero before updating, potentially causing unwanted interrupts.
Also added a flag to the CPU to allow interrupts to be processed sequentially based on the state of the I bit. This one is set to false by default, as it is a significant change in interrupt behavior. Long, and reentrant, ISRs can clear the I bit prematurely to allow themselves to be interrupted.
Lastly, added the I bit to the exported flags for possible use in memory protection schemes. |
jshamlet |
1539d 19h |
/open8_urisc/ |
209 |
Fixed an issue in the PIT timer that caused an immediate interrupt on interval write,
Fixed an issue in the epoch timer that resulted in a spurious interrupt due to extra LSB's being set by default in the set point register,
While cleaning elsewhere, founding a spacing issue in the CPU HDL,
Added a 4k ROM and MW core. |
jshamlet |
1540d 08h |
/open8_urisc/ |
208 |
Removed unnecessary package references |
jshamlet |
1540d 17h |
/open8_urisc/ |
207 |
Added a simple 8-bit, fixed asynchronous serial interface with compile time settable bit-rate, parity enable, and parity mode generics. |
jshamlet |
1541d 10h |
/open8_urisc/ |
206 |
Merged interrupt logic with other clocked process. |
jshamlet |
1545d 05h |
/open8_urisc/ |
205 |
More code and comment cleanup for the new SDLC engine |
jshamlet |
1545d 05h |
/open8_urisc/ |
204 |
Fixed more incorrect comments |
jshamlet |
1545d 06h |
/open8_urisc/ |
203 |
Removed an extra delay FF from the bitclock rising edge signal for the clock slave configuration to better center the rising edge pulse on the receive signal. |
jshamlet |
1545d 12h |
/open8_urisc/ |
202 |
Fixed receiver bug that caused false flag detection,
Split the large sdlc_serial_ctrl entity into sub-entities to make debugging easier. |
jshamlet |
1545d 13h |
/open8_urisc/ |
201 |
Fixed comments regarding RX Checksum location |
jshamlet |
1547d 10h |
/open8_urisc/ |
200 |
Renamed dual-port buffer to match other entities. |
jshamlet |
1547d 10h |
/open8_urisc/ |
199 |
Added monitor ram for debugging and fixed issue with dual-port read path. |
jshamlet |
1547d 10h |
/open8_urisc/ |
198 |
Removed debugging memory |
jshamlet |
1547d 18h |
/open8_urisc/ |
197 |
Fixed incorrect comments |
jshamlet |
1547d 19h |
/open8_urisc/ |
196 |
Modified the update logic to allow direct writes to offset 0xFE for refreshing the clock status. This way, any write to the clock status register will immediately be undone. (Writing 0x00 to offset 0xFF is once-more ignored) |
jshamlet |
1547d 19h |
/open8_urisc/ |
195 |
Added dual-port RAM core for SDLC interface. |
jshamlet |
1548d 14h |
/open8_urisc/ |
194 |
Cleaned up licensing sections |
jshamlet |
1548d 14h |
/open8_urisc/ |
193 |
Fixed incorrect comment in o8_alu16.vhd. The value of the write to 0x1F doesn't matter, as the write itself triggers the calculation. |
jshamlet |
1548d 15h |
/open8_urisc/ |
192 |
Added SDLC packet engine |
jshamlet |
1548d 15h |
/open8_urisc/ |
191 |
Cleaned up comments, added back the OPEN8_NULLBUS constant, and added some new modules for ADCs and LCD displays.
Also made the button input module more configurable by moving the debounce code to a separate entity and using generics to instantiate it. |
jshamlet |
1548d 15h |
/open8_urisc/ |