OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk/] - Rev 272

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
272 When control packets were received, they were ignored in some cases. tadejm 7800d 23h /ethmac/trunk
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.		 mohor 7802d 00h /ethmac/trunk
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7803d 00h /ethmac/trunk
268 Release 1.19. Control frame description changed. mohor 7856d 18h /ethmac/trunk
267 Full duplex control frames tested. mohor 7856d 20h /ethmac/trunk
266 Flow control test almost finished. mohor 7861d 19h /ethmac/trunk
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.		 mohor 7861d 23h /ethmac/trunk
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.		 mohor 7862d 10h /ethmac/trunk
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.		 mohor 7862d 10h /ethmac/trunk
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.		 mohor 7862d 10h /ethmac/trunk
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.		 mohor 7862d 22h /ethmac/trunk
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).		 mohor 7863d 12h /ethmac/trunk
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.		 mohor 7863d 12h /ethmac/trunk
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.		 mohor 7863d 12h /ethmac/trunk
255 TPauseRq synchronized to tx_clk. mohor 7863d 12h /ethmac/trunk
254 Temp version. mohor 7864d 16h /ethmac/trunk
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7864d 18h /ethmac/trunk
252 Just some updates. tadejm 7864d 19h /ethmac/trunk
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.		 mohor 7864d 19h /ethmac/trunk
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.		 mohor 7864d 19h /ethmac/trunk

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.