Rev |
Log message |
Author |
Age |
Path |
113 |
Lots of updates, mostly focused on getting the XuLA board and CPU able to pass
a comprehensive test suite. At this point, everything passes and logic usage
is down even. Among the few changes includes the "break" bit in the uCC
register, used to indicate a switch to supervisor mode occurred as a result
of a user break, and the ability for the supervisor to clear the instruction
cache. |
dgisselq |
2917d 03h |
/xulalx25soc/trunk/sw |
111 |
Added some debug support programs to the repository. |
dgisselq |
2925d 02h |
/xulalx25soc/trunk/sw |
110 |
Fixed a problem whereby block RAM would be declared as a bus error on the
stack, even if the data was valid. |
dgisselq |
2925d 07h |
/xulalx25soc/trunk/sw |
109 |
This continues the updates to the wishbone-uart conversion. It fixes several
bugs within wbuexec, and pipelines the compression scheme. Further, the
read codeword was adjusted so that a read of 8 can be requested with six-bits,
rather than requiring 12. Likewise, the dependence upon the read of 8 on
incrementing the address pointer has been removed. All told, the design
builds for a 200MHz Artix-7, and it has been tested with the CMod-S6. (Writing
flash seems to be one of the most comprehensive tests ...) |
dgisselq |
2925d 11h |
/xulalx25soc/trunk/sw |
105 |
Mostly cosmetic changes. The Makefile now builds a couple more programs,
the documentation is better, etc. |
dgisselq |
2925d 21h |
/xulalx25soc/trunk/sw |
104 |
Updates to the flash driver drawn from the S6SoC project. |
dgisselq |
2925d 21h |
/xulalx25soc/trunk/sw |
103 |
Added a SDSPI scope, and defined which of the four scopes it points to.
(It uses the configuration scopes position, if the configuration scope isn't
defined.) |
dgisselq |
2925d 21h |
/xulalx25soc/trunk/sw |
93 |
Oops -- missed adjusting the copyright. |
dgisselq |
2949d 01h |
/xulalx25soc/trunk/sw |
92 |
Fixes the problem whereby the master counters show when the user counters should
be showing and vice versa. Now the master counters show by default, together
with their correct labels. User counters are still available by pressing
'u' in the debugger, and the master counter display may be returned to by
pressing 'm' in the debugger. |
dgisselq |
2949d 01h |
/xulalx25soc/trunk/sw |
91 |
Fixes bugs associated with an overflow of write acknowledgements in the
receiver. This helps keep our accesses aligned. |
dgisselq |
2949d 01h |
/xulalx25soc/trunk/sw |
78 |
Comments out the line that caused a compiler warning--setting an unused
variable. Code should be better as a result. |
dgisselq |
2954d 21h |
/xulalx25soc/trunk/sw |
77 |
Adds register names and values for the SD card interface. |
dgisselq |
2954d 21h |
/xulalx25soc/trunk/sw |
76 |
Now tries to avoid reading from the stack if the stack addresses are already
known to be bad. That way, the debugger tries to preserve any bus error address
already on the buserr device. |
dgisselq |
2954d 21h |
/xulalx25soc/trunk/sw |
53 |
Added a touch of error checking. |
dgisselq |
3002d 23h |
/xulalx25soc/trunk/sw |
49 |
Added some documentation to make the read and write calls easier to understand. |
dgisselq |
3031d 00h |
/xulalx25soc/trunk/sw |
46 |
This is a bug fix release--fixing the bug that kept dumpsdram.cpp/wbsdram.v
from working when long pipelined reads were interrupted by the necessity of
a pair of refresh cycles. |
dgisselq |
3033d 02h |
/xulalx25soc/trunk/sw |
42 |
Minor changes. |
dgisselq |
3036d 21h |
/xulalx25soc/trunk/sw |
41 |
Bug fix. This was preventing dumpsdram from accurately reading back what
had been written to the RAM earlier. |
dgisselq |
3036d 21h |
/xulalx25soc/trunk/sw |
40 |
This adds to dumpsdram the capability to run over a port, such as with
busmaster_tb. |
dgisselq |
3038d 08h |
/xulalx25soc/trunk/sw |
38 |
Updated to remove the build dependence upon ZipCPU. |
dgisselq |
3040d 07h |
/xulalx25soc/trunk/sw |