Rev |
Log message |
Author |
Age |
Path |
264 |
Updated comments |
jshamlet |
1555d 15h |
/ |
263 |
Fixed a very old bug in the CPU core where autoincrements weren't affecting the upper register in the pair, causing it to loop around the lower 256 bytes. This only affected LDX/LDO, as the proper ALU signals were being generated in STO/STX and UPP. Wow, that bug has been in there for AGES.
Also separated the SDLC TX and RX interrupts so that they could be handled separately. |
jshamlet |
1555d 16h |
/ |
262 |
Added comments to LCD controllers - specifically that reading either register 0 or 1 will return the ready status. This code was already present, but not mentioned in the register map. |
jshamlet |
1564d 19h |
/ |
261 |
Increased delay timer to 7 bits for button press detection. |
jshamlet |
1571d 19h |
/ |
260 |
Added missing comments for Sequential_Interrupts generic, as well as comments explaining portions of the CPU operations. |
jshamlet |
1584d 18h |
/ |
259 |
Fixed issue where Write_Fault wasn't defaulting to '0' when Write_Protect was set to FALSE,
Added a pulse interval measurement entity,
Fixed comments. |
jshamlet |
1584d 20h |
/ |
258 |
Fixed write bug in o8_ltc2355_2p.vhd, added a newer Open8_cfg.vhd, and the sys_tick.vhd utility entity. |
jshamlet |
1585d 17h |
/ |
257 |
Fixed misnamed signal in o8_7seg.vhd and added a replacement switch interface that handles both static and pushbutton switches. |
jshamlet |
1585d 18h |
/ |
256 |
Removed unused generic from the status_led.vhd and cleaned up comments on the CPU |
jshamlet |
1585d 19h |
/ |
255 |
Modified code to make ModelSim happy (It didn't like the generate blocks for some reason). Also added a block describing the new generic. |
jshamlet |
1586d 00h |
/ |
254 |
Simplified the ISR address logic so that the upper 12 bits are constant (set by generic) and only the lower 4 bits are registered/computed. |
jshamlet |
1586d 14h |
/ |
253 |
Fixed spelling error in comment |
jshamlet |
1586d 15h |
/ |
252 |
(This time the CPU model was included...)
Added the ability to use unsigned offsets to the LDO/STO instructions. The original behavior of signed offsets is preserved if the Unsigned_Index_Offsets is left unset or set to FALSE. While inserting this code, pipeline registers were also inserted into the address generation logic for indexed instructions. This simplifies the final multiplexor and improves FMax at the slight expense of LDO/SDO now taking one additional clock cycle to execute. |
jshamlet |
1586d 15h |
/ |
251 |
Added RAM write fault detection, which can be used to indicate a memory write violation by the CPU. This allows a clean shutdown in the event of a memory problem/program crash.
Fixed a bug in the status_led.vhd entity that kept the flashing light function from working. The new code uses a maximal length 24-bit LFSR to create long delays. This is more efficient than a binary counter, but results in non-exact frequencies as a function of SYSTEM_FREQUENCY / (2^24-1).
Added the ability to use unsigned offsets to the LDO/STO instructions. The original behavior of signed offsets is preserved if the Unsigned_Index_Offsets is left unset or set to FALSE. While inserting this code, pipeline registers were also inserted into the address generation logic for indexed instructions. This simplifies the final multiplexor and improves FMax at the slight expense of LDO/SDO now taking one additional clock cycle to execute. |
jshamlet |
1586d 15h |
/ |
250 |
Removed monitor RAM from SDLC model, as it is now proven to work. |
jshamlet |
1590d 23h |
/ |
249 |
Added a 32-bit wide register and split the status_led core from o8_status_led.vhd, allowing it to be used as a subcomponent elsewhere. |
jshamlet |
1602d 15h |
/ |
248 |
Removed Default_Int_Flag generic from CPU, as it is duplicated by Supervisor_Mode. |
jshamlet |
1602d 23h |
/ |
247 |
Fixed problem where parallel interface was always forcing the data registers due to bad alias. |
jshamlet |
1603d 16h |
/ |
246 |
The system timer module now allows for an optional millisecond resolution (settable through a generic). This prescalar enable permits the timer to operate from 1 to 256 mS, which is useful for a variety of tasks, such as serial timeouts and watchdog timers. The enable is not software settable, as this would complicate the register interface and isn't generally useful in an HDL based SOC design.
The vector interface now has a parallel interface that runs beside the serial interface, and is useful for connecting to DIO cards or other parallel interfaces. |
jshamlet |
1603d 21h |
/ |
245 |
Modified the CPU's Supervisor_Mode to also protect SMSK and RSP instructions,
Added an external interrupt manager, o8_int_mgr.vhd. |
jshamlet |
1605d 20h |
/ |