Rev |
Log message |
Author |
Age |
Path |
263 |
Fixed a very old bug in the CPU core where autoincrements weren't affecting the upper register in the pair, causing it to loop around the lower 256 bytes. This only affected LDX/LDO, as the proper ALU signals were being generated in STO/STX and UPP. Wow, that bug has been in there for AGES.
Also separated the SDLC TX and RX interrupts so that they could be handled separately. |
jshamlet |
1490d 03h |
/open8_urisc/trunk |
262 |
Added comments to LCD controllers - specifically that reading either register 0 or 1 will return the ready status. This code was already present, but not mentioned in the register map. |
jshamlet |
1499d 06h |
/open8_urisc/trunk |
261 |
Increased delay timer to 7 bits for button press detection. |
jshamlet |
1506d 06h |
/open8_urisc/trunk |
260 |
Added missing comments for Sequential_Interrupts generic, as well as comments explaining portions of the CPU operations. |
jshamlet |
1519d 05h |
/open8_urisc/trunk |
259 |
Fixed issue where Write_Fault wasn't defaulting to '0' when Write_Protect was set to FALSE,
Added a pulse interval measurement entity,
Fixed comments. |
jshamlet |
1519d 07h |
/open8_urisc/trunk |
258 |
Fixed write bug in o8_ltc2355_2p.vhd, added a newer Open8_cfg.vhd, and the sys_tick.vhd utility entity. |
jshamlet |
1520d 05h |
/open8_urisc/trunk |
257 |
Fixed misnamed signal in o8_7seg.vhd and added a replacement switch interface that handles both static and pushbutton switches. |
jshamlet |
1520d 06h |
/open8_urisc/trunk |
256 |
Removed unused generic from the status_led.vhd and cleaned up comments on the CPU |
jshamlet |
1520d 06h |
/open8_urisc/trunk |
255 |
Modified code to make ModelSim happy (It didn't like the generate blocks for some reason). Also added a block describing the new generic. |
jshamlet |
1520d 11h |
/open8_urisc/trunk |
254 |
Simplified the ISR address logic so that the upper 12 bits are constant (set by generic) and only the lower 4 bits are registered/computed. |
jshamlet |
1521d 02h |
/open8_urisc/trunk |
253 |
Fixed spelling error in comment |
jshamlet |
1521d 02h |
/open8_urisc/trunk |
252 |
(This time the CPU model was included...)
Added the ability to use unsigned offsets to the LDO/STO instructions. The original behavior of signed offsets is preserved if the Unsigned_Index_Offsets is left unset or set to FALSE. While inserting this code, pipeline registers were also inserted into the address generation logic for indexed instructions. This simplifies the final multiplexor and improves FMax at the slight expense of LDO/SDO now taking one additional clock cycle to execute. |
jshamlet |
1521d 02h |
/open8_urisc/trunk |
251 |
Added RAM write fault detection, which can be used to indicate a memory write violation by the CPU. This allows a clean shutdown in the event of a memory problem/program crash.
Fixed a bug in the status_led.vhd entity that kept the flashing light function from working. The new code uses a maximal length 24-bit LFSR to create long delays. This is more efficient than a binary counter, but results in non-exact frequencies as a function of SYSTEM_FREQUENCY / (2^24-1).
Added the ability to use unsigned offsets to the LDO/STO instructions. The original behavior of signed offsets is preserved if the Unsigned_Index_Offsets is left unset or set to FALSE. While inserting this code, pipeline registers were also inserted into the address generation logic for indexed instructions. This simplifies the final multiplexor and improves FMax at the slight expense of LDO/SDO now taking one additional clock cycle to execute. |
jshamlet |
1521d 02h |
/open8_urisc/trunk |
250 |
Removed monitor RAM from SDLC model, as it is now proven to work. |
jshamlet |
1525d 10h |
/open8_urisc/trunk |
249 |
Added a 32-bit wide register and split the status_led core from o8_status_led.vhd, allowing it to be used as a subcomponent elsewhere. |
jshamlet |
1537d 02h |
/open8_urisc/trunk |
248 |
Removed Default_Int_Flag generic from CPU, as it is duplicated by Supervisor_Mode. |
jshamlet |
1537d 10h |
/open8_urisc/trunk |
247 |
Fixed problem where parallel interface was always forcing the data registers due to bad alias. |
jshamlet |
1538d 03h |
/open8_urisc/trunk |
246 |
The system timer module now allows for an optional millisecond resolution (settable through a generic). This prescalar enable permits the timer to operate from 1 to 256 mS, which is useful for a variety of tasks, such as serial timeouts and watchdog timers. The enable is not software settable, as this would complicate the register interface and isn't generally useful in an HDL based SOC design.
The vector interface now has a parallel interface that runs beside the serial interface, and is useful for connecting to DIO cards or other parallel interfaces. |
jshamlet |
1538d 08h |
/open8_urisc/trunk |
245 |
Modified the CPU's Supervisor_Mode to also protect SMSK and RSP instructions,
Added an external interrupt manager, o8_int_mgr.vhd. |
jshamlet |
1540d 07h |
/open8_urisc/trunk |
244 |
Added two new generics to the CPU model. The first is a supervisory mode that disables the STP PSR_I instruction. This prevents errant code execution from setting the I bit, and disabling any subsequent memory protection logic. The second allows the default state of the I bit to be set at startup. If set true, initialization code will run with the I bit set, allowing it to bypass memory protection.
Also modified the RAM models to include write mask logic, where the mask register is write-protected by the I bit in the CPU. When enabled, the models will prevent code from writing to memory regions which do not have their mask bits set. The upshot is that code can effectively "write protect" the RAM - which is useful for multitasking applications.
Also, most modules have been updated with write qualification inputs, allowing a similar scheme to be used for I/O, though not as elegantly. I use a register module, whose own write qual line is attached to the external copy of the I bit as an I/O write protect register.
Lastly, added a new externally triggered timer, which can generate pulses with programmable delays and widths, and which can interrupt on either the input trigger, the output rising edge, or output falling edge. The time base can be either the internal microsecond tick signal, or an external clock. |
jshamlet |
1541d 04h |
/open8_urisc/trunk |