Rev |
Log message |
Author |
Age |
Path |
1244 |
Added "cm" command to copy data inside memory.
Make or1ksim work on little endian platforms.
Port to Mac OS X.
Some bugfixes.
Allow JTAG write access to read-only memory regions. |
hpanther |
7528d 08h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1165 |
timeout bug fixed; contribution by Carlos |
markom |
7767d 07h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1153 |
When multiple interrupts were pending, e.g. TX buffer empty and RX
available, reading the UART's IIR register could potentially clear a
TX interrupt before it had been sent to the processor, thus dropping
the interrupt permanently.
Fix tested w/ both eCos and uclinux. |
sfurman |
7825d 02h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1145 |
1) Fix trivial bug w/ transmitter empty interrupts that I introduced in the
last check-in.
2) Improve printed output from debugging-only uart_status() routine. |
sfurman |
7825d 20h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1143 |
Make UART transmitter-empty interrupts match both 16450 and 16550 behavior. |
sfurman |
7828d 16h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1116 |
There was a bug in the simulator's UART implementation that caused the
UART's LSR register to become corrupted. This was due to an
assumption that 'char' is an unsigned type, but that is not true on
all platforms.
When the char type is signed and a character is read in the range
0x80-0xff, the high bit is sign-extended into the upper bits of an
entry in the receive FIFO. When the character reaches the head of the
FIFO, the upper bits of the FIFO entry are OR'ed into the LSR, causing
the LSR to be set to 0xFF.
A simple cast fixes the problem. |
sfurman |
7869d 00h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
1073 |
channels support |
rprescott |
7994d 04h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
997 |
PRINTF should be used instead of printf; command redirection repaired |
markom |
8057d 14h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
970 |
Testbench is now running on ORP architecture platform. |
simons |
8065d 01h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
884 |
code cleaning - a lot of global variables moved to runtime struct |
markom |
8101d 12h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
821 |
ugly bug with duplicate redefined i removed |
markom |
8187d 08h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
806 |
uart now partially uses scheduler |
markom |
8192d 15h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
805 |
kbd, fb, vga devices now uses scheduler |
markom |
8192d 15h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
713 |
lot of small minor improvements: code documented, cleaned; runs at about same speed when not actually logging, but exe_log is enabled; raw_stats now run only with simple execution - enable RAW_USAGE_STATS macro |
markom |
8229d 13h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
549 |
enabled parameters removed from devices, which also have number of devices; command line --output-cfg parameter added |
markom |
8283d 09h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
530 |
THRI interrupt fixed. |
simons |
8286d 02h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
529 |
Bug in receiver fixed. |
simons |
8286d 04h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
492 |
uart THRE interrupt immedialty after write to IER |
markom |
8302d 12h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
490 |
clkcycle parsing problem fixed |
markom |
8303d 08h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |
424 |
memory configuration file joined into .cfg file; *mem.cfg are obsolete; read-only and write-only memory is supported; memory logging is not yet supported; update of testbench - only cache test fails, since it writes to RO memory |
markom |
8312d 12h |
/or1k/tags/nog_patch_42/or1ksim/peripheral/16450.c |