OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] - Rev 64

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
64 Support latest Xilinx ISE 14.5 software. csantifort 4091d 14h /amber/trunk/hw/
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4091d 19h /amber/trunk/hw/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4378d 13h /amber/trunk/hw/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4596d 09h /amber/trunk/hw/
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4666d 07h /amber/trunk/hw/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4666d 10h /amber/trunk/hw/
57 Add some debug messages csantifort 4666d 10h /amber/trunk/hw/
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.
csantifort 4666d 10h /amber/trunk/hw/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4683d 10h /amber/trunk/hw/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4698d 08h /amber/trunk/hw/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4698d 08h /amber/trunk/hw/
50 Revert to previous version csantifort 4739d 08h /amber/trunk/hw/
49 Added a note n how to change timeouts csantifort 4739d 08h /amber/trunk/hw/
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.
csantifort 4743d 14h /amber/trunk/hw/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4763d 12h /amber/trunk/hw/
45 Store vmlinux.mem and vmlinux.dis in compressed form csantifort 4771d 09h /amber/trunk/hw/
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.
csantifort 4771d 10h /amber/trunk/hw/
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4789d 06h /amber/trunk/hw/
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 4790d 15h /amber/trunk/hw/
40 Added wishbone bus jitter testing option.
Cleaned up waveform log .do files, now seperate files for a23 and a25 cores.
Added vmlinux executable elf file for running on hardware.
csantifort 4795d 07h /amber/trunk/hw/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.