OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] - Rev 67

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
67 renamed boot-loader.c to boot-loader-serial.c csantifort 4209d 02h /amber/trunk/hw/
64 Support latest Xilinx ISE 14.5 software. csantifort 4209d 03h /amber/trunk/hw/
63 Add support for Xilinx ISim Verilog simulator.
Remove Virtex-6 files.
csantifort 4209d 07h /amber/trunk/hw/
61 Add new netowkr based boot loader.
Remove support for Virtex. Spartan 6 only now.
csantifort 4496d 02h /amber/trunk/hw/
60 Bug fix; removed a combinational loop from the a25_decode logic. csantifort 4713d 22h /amber/trunk/hw/
59 Added modelsim script for reloading a wlf file after a simulation has been rerun. csantifort 4783d 19h /amber/trunk/hw/
58 Use TB.clk_count for the decompiler messages and removed the local counter csantifort 4783d 23h /amber/trunk/hw/
57 Add some debug messages csantifort 4783d 23h /amber/trunk/hw/
56 Remove the timeouts file from svn. Its an output file and gets now just gets created automatically
when sims are run for the first time.
csantifort 4783d 23h /amber/trunk/hw/
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.
csantifort 4800d 22h /amber/trunk/hw/
53 Cleaned up Amber Verilog, removing unused signals. csantifort 4815d 20h /amber/trunk/hw/
52 Fixed typo in notes on creating DDR memory interfaces using coregen csantifort 4815d 20h /amber/trunk/hw/
50 Revert to previous version csantifort 4856d 20h /amber/trunk/hw/
49 Added a note n how to change timeouts csantifort 4856d 20h /amber/trunk/hw/
48 Fixed a bug in linux that caused the os to not return to the running application after an interrupt.
Hello-world now runs stand-alone again.
Added initrd-200k-dhry, a disk image that uses the dhry program for init.
csantifort 4861d 03h /amber/trunk/hw/
47 Changed V6 VCo from 1000Mhz to 1200 MHz csantifort 4881d 00h /amber/trunk/hw/
45 Store vmlinux.mem and vmlinux.dis in compressed form csantifort 4888d 22h /amber/trunk/hw/
43 Added support for the flat executable file format to vmlinux, so that the hello-world program is correctly relocated when it is loaded at the end of the vmlinux test.
Changed the Virtex-5 clock configuration to use a 1200MHz VCO frequency and 80MHz system clock frequency.
csantifort 4888d 22h /amber/trunk/hw/
42 Added write buffer - fixes bug if wishbone writes takes multiple cycles to complete csantifort 4906d 19h /amber/trunk/hw/
41 Added instructions on how to use Coregen to create the Spartan-6 DDR3 memory interface. csantifort 4908d 03h /amber/trunk/hw/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.