OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [trunk/] - Rev 161

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
161 Correcting configure parameters of adv_jtag_bridge on installation script. rfajardo 4686d 04h /minsoc/trunk/
160 Typo in minsoc-install.sh script. Adv_jtag_bridge was not configuring correctly. rfajardo 4686d 04h /minsoc/trunk/
159 Updated constraint file for de2_115 board. (Richard Hasha) rfajardo 4686d 05h /minsoc/trunk/
158 Adding de2_115_board port, thanks to Richard Hasha.

Support to JSP (JTAG Serial Port) working well. Also provided by Richard Hasha.

Different interconnect configurations per board are not straightforward on MinSoC. New added modules or definitions for addresses have to be carried over to other boards. Furthermore, extra modules can be shared among all projects. Thus, it is better to have this centralized:
-Removing interconnect configuration from minsoc_defines.v. There is an interconnect_defines.v file on rtl/verilog. The software counterpart is interconnect.h on sw/drivers.

Including a jsp firmware. It is basically the uart firmware but using JSP instead. Added to all board configure scripts to be compiled on configuration.

prj/srcs extended to include jsp and interconnec_defines.v.

spartan3e_starter_kit_eth lost UART (does not fit) and uses JSP instead now.		 rfajardo 4687d 21h /minsoc/trunk/
157 Removed obsolete file; the changes in this version have been merged into
the mainline advanced debug system version 3.0 and higher.		 nyawn 4693d 16h /minsoc/trunk/
156 Added hardware watchpoint indicators to debug unit break input, to allow
the debugger to break when a hardware watchpoint is triggered.		 nyawn 4693d 16h /minsoc/trunk/
155 Decreased wait time, for faster simulations. nyawn 4693d 16h /minsoc/trunk/
154 Modified to use the new autotools support in the advanced debug system v3.0. nyawn 4693d 16h /minsoc/trunk/
149 Merging differences of release candidate 1.0 revision 140:148 with trunk. rfajardo 4726d 06h /minsoc/trunk/
144 Updating configure scripts. Calling make into the right directories now. rfajardo 4732d 05h /minsoc/trunk/
142 Updating configure.sh:
1) we don't patch the trunk version.
2) it is better to re-compile the firmwares on reconfiguration. So compiling firmwares went to configure scripts instead.

backend/xxx/configure: compiling firmwares here now.		 rfajardo 4732d 06h /minsoc/trunk/
141 Merging with rc-1.0 revision 140. I doubt rc-1.0 will still change much in the last days. rfajardo 4732d 06h /minsoc/trunk/
135 Installation on Ubuntu-11.10 has shown that package texinfo is required to compiled GDB. This package installs the binary makeinfo. rfajardo 4740d 01h /minsoc/trunk/
108 Scripts updates to correct paths when working under Windows. Now, ModelSim, Xilinx and Altera synthesis are working on Windows through batch files.

Icarus Verilog and Altera synthesis are working as well. Job done!		 rfajardo 4759d 00h /minsoc/trunk/
107 Adding setup batch script for Altera synthesis on Windows.

prj/scripts/altprj.sh has now to check if it is run from cygwin in order to re-formulate the path to windows system.

Maybe the other scripts have to be updated too. This will be checked soon.		 rfajardo 4759d 03h /minsoc/trunk/
106 Installation script was checking the ENV variable before setting it. rfajardo 4759d 05h /minsoc/trunk/
105 Updating configure scripts to copy Windows synthesis launch script setup.bat from either minsoc/syn/altera or minsoc/syn/xilinx to minsoc/syn. rfajardo 4759d 07h /minsoc/trunk/
104 Enabling modelsim simulation for current project definition.
vhdl and verilog projects have to be separated:
-prj/Makefile defines VHDL_PROJECTS and VERILOG_PROJECTS, they are merged into PROJECTS. Tools which don't care about VHDL or Verilog use PROJECTS list while other tools use VERILOG_ or VHDL_PROJECTS.
-Simulation uses VHDL_PROJECTS and VERILOG_PROJECTS independently.
-prj/scripts/simprj.sh splitted in:
-simvhdl.sh
-simverilog.sh
(they generate the input files in the right format for simulation tools)		 rfajardo 4766d 06h /minsoc/trunk/
103 But the file is called gdb-6.8a.tar.bz2, so tar must be run on that name. rfajardo 4768d 21h /minsoc/trunk/
102 GNU GDB FTP has renamed gdb-6.8 package to gdb-6.8a package. Uncompressed it remains gdb-6.8, so no other changes to script are necessary. rfajardo 4768d 21h /minsoc/trunk/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.