OpenCores
URL https://opencores.org/ocsvn/xulalx25soc/xulalx25soc/trunk

Subversion Repositories xulalx25soc

[/] - Rev 91

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
91 Fixes bugs associated with an overflow of write acknowledgements in the
receiver. This helps keep our accesses aligned.		 dgisselq 3088d 18h /
90 Reads and writes to the SD over SPI port now work. The card appears, as of now,
to be fully functional.		 dgisselq 3088d 18h /
89 Bug fixes, following the adf_ce logic combining ALU/DIVIDE/FPU pipeline logic
into one register, this fixes that logic so that instructions without their
condition fulfilled are still "executed" and marked as done.		 dgisselq 3088d 18h /
88 Adjusted copyright date. dgisselq 3088d 18h /
87 Placed the interrupt into the carry chain for less logic area. dgisselq 3088d 18h /
86 Fine tuning the `defines, so that you can build pipelined without pipelined
bus access and so forth.		 dgisselq 3088d 18h /
85 First version of the SD-SPI interface, with partial functionality. (No the
empty link that was here before.)		 dgisselq 3092d 15h /
84 First part of switching to proper sdspi.v, and not just the link. dgisselq 3092d 15h /
83 Fixes a bug in the LX9 build whereby the flash was never ever granted permission
to use the SPI port.		 dgisselq 3093d 19h /
82 dgisselq 3094d 14h /
81 Adds register values for the SD-Card registers. dgisselq 3094d 14h /
80 Currently working version: contains both a working DMA controller as well as
a working (as far as I can tell) SD-Card controller (writes not yet tested).		 dgisselq 3094d 14h /
79 Adds 'bench' and 'sw' targets, and automatically builds them (now). dgisselq 3094d 14h /
78 Comments out the line that caused a compiler warning--setting an unused
variable. Code should be better as a result.		 dgisselq 3094d 14h /
77 Adds register names and values for the SD card interface. dgisselq 3094d 14h /
76 Now tries to avoid reading from the stack if the stack addresses are already
known to be bad. That way, the debugger tries to preserve any bus error address
already on the buserr device.		 dgisselq 3094d 14h /
75 Added simulation capability for the SD-Card, as well as debugging output for the
DMA. (The SD-Card debug may not be fully featured, yet, but it has gotten me
to where I can talk to the card.)		 dgisselq 3094d 14h /
74 Adds the SD-card capability, and connects the debug wires to/from the uartdev
in case it needs to be debugged.		 dgisselq 3094d 14h /
73 Simplified logic. dgisselq 3094d 14h /
72 Sets XULA25 as the default. dgisselq 3094d 15h /

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.