OpenCores
URL https://opencores.org/ocsvn/amber/amber/trunk

Subversion Repositories amber

[/] [amber/] [trunk/] [hw/] [vlog/] [amber23/] [a23_execute.v] - Rev 82

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
82 Fixed overflag bug, ldmia user regs bug and status_bits_mode set on non-ececuting command bug csantifort 3342d 03h /amber/trunk/hw/vlog/amber23/a23_execute.v
74 The patch implements barrel shifter using rotate as a main primitive.
The design was optimized for Altera Cyclone III FPGA and can be reused
with other FPGA vendors and products.
The patch integrates the FPGA-optimized barrel shifter into the
Amber 23 core when it is build for Altera FPGA.

The patch reduces footprint from 1178 to 339 LEs keeping Fmax at 57-60 MHz.

Contributed by: Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>		 csantifort 4028d 09h /amber/trunk/hw/vlog/amber23/a23_execute.v
73 The patch introduces a new configuration option `A23_RAM_REGISTER_BANK,
which controls instantiation of Amber 23 register bank.
If the option is set, a ram-based variant of the register bank is instantiated.
It can be useful in low-end FPGA designs, where flipflops and muxes are costly.

Altera Cyclone III resource utilization:
- flipflop-based register bank: 1583 combinationals + 856 registers
- ram-based register bank: 268 combinationals + 156 registers

Contributed by Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>		 csantifort 4028d 09h /amber/trunk/hw/vlog/amber23/a23_execute.v
72 5 bit "OH_USR" constant was used when 2 bit "USR" should be used.
Both of the constants are 0.
The fault was introduced by ram-based register bank commit.
Contributed by: Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>		 csantifort 4028d 09h /amber/trunk/hw/vlog/amber23/a23_execute.v
71 Original Amber 23 core uses asyncronous implementation of register bank.
It leads to some problems with ram-based implementation of the register bank,
because at least Altera FPGAs uses syncronous ram blocks, so the whole address
needs to be latched.

The patch exposes non-registered versions of register select signals to the
register bank, so the bank can build address and latch it in the syncronous
ram input register.

The patch is a pre-requisite for ram-based register bank implementation on Altera FPGA.

Contributed by Dmitry Tarnyagin <dmitry.tarnyagin@lockless.no>		 csantifort 4028d 09h /amber/trunk/hw/vlog/amber23/a23_execute.v
54 Bug fix for bug reported by Botao Lee. The mode bits in the decode stage did not change immediately
after a mode switch from a teqp instruction, but 1 cycle later. This meant the wrong set of registers
was selected for writing to for 1 clock cycle.		 csantifort 4620d 06h /amber/trunk/hw/vlog/amber23/a23_execute.v
15 Copied amber to amber23, Many system changes to support new amber25 core. csantifort 4827d 23h /amber/trunk/hw/vlog/amber23/a23_execute.v
2 Baseline release of the Amber 2 core csantifort 4858d 09h /amber/trunk/hw/vlog/amber/a23_execute.v

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.