Subversion Repositories ethmac

[/] - Rev 277


Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
277 When padding was enabled and crc disabled, frame was not ended correctly. mohor 7743d 20h /
276 Defer indication changed. tadejm 7743d 20h /
275 Fix MTxErr or prevent sending too big frames. mohor 7751d 01h /
274 Backup version. Not fully working. tadejm 7751d 14h /
273 This commit was manufactured by cvs2svn to create tag 'rel_15'. 7751d 20h /
272 When control packets were received, they were ignored in some cases. tadejm 7751d 20h /
271 This commit was manufactured by cvs2svn to create tag 'rel_14'. 7752d 22h /
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.
mohor 7752d 22h /
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7753d 22h /
268 Release 1.19. Control frame description changed. mohor 7807d 15h /
267 Full duplex control frames tested. mohor 7807d 17h /
266 Flow control test almost finished. mohor 7812d 16h /
265 This commit was manufactured by cvs2svn to create tag 'rel_13'. 7812d 20h /
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7812d 20h /
263 test_mac_full_duplex_flow_control tests pretty much finished.
FRM. AT 4 TX BD ( 10Mbps ) finished.
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 7813d 08h /
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 7813d 08h /
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
mohor 7813d 08h /
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
mohor 7813d 20h /
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7814d 09h /
258 This commit was manufactured by cvs2svn to create tag 'rel_12'. 7814d 09h /
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7814d 09h /
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7814d 10h /
255 TPauseRq synchronized to tx_clk. mohor 7814d 10h /
254 Temp version. mohor 7815d 13h /
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7815d 16h /
252 Just some updates. tadejm 7815d 16h /
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7815d 16h /
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 7815d 16h /
249 This commit was manufactured by cvs2svn to create tag 'rel_11'. 7816d 16h /
248 wb_rst_i is used for MIIM reset. mohor 7816d 16h /

powered by: WebSVN 2.1.0

© copyright 1999-2024, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.