OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [tags/] [rel_20] - Rev 274

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
274 Backup version. Not fully working. tadejm 7781d 03h /ethmac/tags/rel_20
272 When control packets were received, they were ignored in some cases. tadejm 7781d 09h /ethmac/tags/rel_20
270 When receiving normal data frame and RxFlow control was switched on, RXB
interrupt was not set.		 mohor 7782d 11h /ethmac/tags/rel_20
269 When in full duplex, transmit was sometimes blocked. Fixed. mohor 7783d 11h /ethmac/tags/rel_20
268 Release 1.19. Control frame description changed. mohor 7837d 04h /ethmac/tags/rel_20
267 Full duplex control frames tested. mohor 7837d 07h /ethmac/tags/rel_20
266 Flow control test almost finished. mohor 7842d 06h /ethmac/tags/rel_20
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.		 mohor 7842d 10h /ethmac/tags/rel_20
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.		 mohor 7842d 21h /ethmac/tags/rel_20
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.		 mohor 7842d 21h /ethmac/tags/rel_20
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.		 mohor 7842d 21h /ethmac/tags/rel_20
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.		 mohor 7843d 09h /ethmac/tags/rel_20
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).		 mohor 7843d 22h /ethmac/tags/rel_20
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.		 mohor 7843d 23h /ethmac/tags/rel_20
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.		 mohor 7843d 23h /ethmac/tags/rel_20
255 TPauseRq synchronized to tx_clk. mohor 7843d 23h /ethmac/tags/rel_20
254 Temp version. mohor 7845d 03h /ethmac/tags/rel_20
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7845d 05h /ethmac/tags/rel_20
252 Just some updates. tadejm 7845d 05h /ethmac/tags/rel_20
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.		 mohor 7845d 05h /ethmac/tags/rel_20

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.