OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [tags/] [rel_24/] - Rev 266

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
266 Flow control test almost finished. mohor 7258d 15h /ethmac/tags/rel_24/
264 Registers RxStatusWrite_rck and RxStatusWriteLatched were not used
anywhere. Removed.
mohor 7258d 19h /ethmac/tags/rel_24/
263 test_mac_full_duplex_flow_control tests pretty much finished.
TEST 0: INSERT CONTROL FRM. WHILE TRANSMITTING NORMAL
FRM. AT 4 TX BD ( 10Mbps ) finished.
TEST 2: RECEIVE CONTROL FRAMES WITH PASSALL OPTION
TURNED OFF AT ONE RX BD ( 10Mbps ) finished.
mohor 7259d 06h /ethmac/tags/rel_24/
262 Version 1.18 released.
MIIMRST (Reset of the MIIM module) not used any more in the MIIMODER
register. Control Frame bit (CF) added to the RX buffer descriptor. Control
frame detection section updated.
mohor 7259d 07h /ethmac/tags/rel_24/
261 Rx Flow control fixed. CF flag added to the RX buffer descriptor. RxAbort
synchronized.
mohor 7259d 07h /ethmac/tags/rel_24/
260 test_mac_full_duplex_flow test 0 finished. Sending the control (PAUSE) frame
finished.
mohor 7259d 19h /ethmac/tags/rel_24/
259 In loopback rx_clk is not looped back. Possible CRC error. Consider if usage
of additional logic is necessery (FIFO for looping the data).
mohor 7260d 08h /ethmac/tags/rel_24/
257 When TxUsedData and CtrlMux occur at the same time, byte counter needs
to be incremented by 2. Signal IncrementByteCntBy2 added for that reason.
mohor 7260d 08h /ethmac/tags/rel_24/
256 TxDone and TxAbort changed so they're not propagated to the wishbone
module when control frame is transmitted.
mohor 7260d 08h /ethmac/tags/rel_24/
255 TPauseRq synchronized to tx_clk. mohor 7260d 08h /ethmac/tags/rel_24/
254 Temp version. mohor 7261d 12h /ethmac/tags/rel_24/
253 r_MiiMRst is not used for resetting the MIIM module. wb_rst used instead. mohor 7261d 14h /ethmac/tags/rel_24/
252 Just some updates. tadejm 7261d 15h /ethmac/tags/rel_24/
251 When control frame (PAUSE) was sent, status was written in the
eth_wishbone module and both TXB and TXC interrupts were set. Fixed.
Only TXC interrupt is set.
mohor 7261d 15h /ethmac/tags/rel_24/
250 AddressMiss status is connecting to the Rx BD. AddressMiss is identifying
that a frame was received because of the promiscous mode.
mohor 7261d 15h /ethmac/tags/rel_24/
248 wb_rst_i is used for MIIM reset. mohor 7262d 15h /ethmac/tags/rel_24/
246 Since r_Rst bit is not used any more, default value is changed to 0xa000. mohor 7265d 18h /ethmac/tags/rel_24/
245 Rev 1.7. mohor 7266d 12h /ethmac/tags/rel_24/
244 r_Rst signal does not reset any module any more and is removed from the design. mohor 7266d 14h /ethmac/tags/rel_24/
243 Late collision is not reported any more. tadejm 7266d 19h /ethmac/tags/rel_24/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2022 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.