OpenCores
URL https://opencores.org/ocsvn/ethmac/ethmac/trunk

Subversion Repositories ethmac

[/] [ethmac/] [trunk/] [rtl/] [verilog/] - Rev 43

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
43 Tx status is written back to the BD. mohor 7900d 21h /ethmac/trunk/rtl/verilog/
42 Rx status is written back to the BD. mohor 7903d 14h /ethmac/trunk/rtl/verilog/
41 non-DMA host interface added. Select the right configutation in eth_defines. mohor 7905d 16h /ethmac/trunk/rtl/verilog/
40 Both rx and tx part are finished. Tested with wb_clk_i between 10 and 200
MHz. Statuses, overrun, control frame transmission and reception still need
to be fixed.
mohor 7906d 14h /ethmac/trunk/rtl/verilog/
39 Tx part finished. TxStatus needs to be fixed. Pause request needs to be
added.
mohor 7910d 18h /ethmac/trunk/rtl/verilog/
38 Initial version. Equals to eth_wishbonedma.v at this moment. mohor 7919d 20h /ethmac/trunk/rtl/verilog/
37 Link in the header changed. mohor 7919d 20h /ethmac/trunk/rtl/verilog/
34 RX_BD_NUM changed to TX_BD_NUM (holds number of TX descriptors
instead of the number of RX descriptors).
mohor 7968d 15h /ethmac/trunk/rtl/verilog/
33 ETH_RX_BD_ADR register deleted. ETH_RX_BD_NUM is used instead. mohor 7968d 20h /ethmac/trunk/rtl/verilog/
32 ETH_RX_BD_ADR register deleted. ETH_RX_BD_NUM is used instead. mohor 7968d 20h /ethmac/trunk/rtl/verilog/
29 Generic memory model is used. Defines are changed for the same reason. mohor 7990d 16h /ethmac/trunk/rtl/verilog/
24 Log file added. mohor 8015d 19h /ethmac/trunk/rtl/verilog/
23 Number of addresses (wb_adr_i) minimized. mohor 8015d 19h /ethmac/trunk/rtl/verilog/
22 eth_timescale.v changed to timescale.v This is done because of the
simulation of the few cores in a one joined project.
mohor 8015d 22h /ethmac/trunk/rtl/verilog/
21 Status signals changed, Adress decoding changed, interrupt controller
added.
mohor 8016d 18h /ethmac/trunk/rtl/verilog/
20 Defines changed (All precede with ETH_). Small changes because some
tools generate warnings when two operands are together. Synchronization
between two clocks domains in eth_wishbonedma.v is changed (due to ASIC
demands).
mohor 8040d 15h /ethmac/trunk/rtl/verilog/
18 Few little NCSIM warnings fixed. mohor 8053d 16h /ethmac/trunk/rtl/verilog/
17 Signal names changed on the top level for easier pad insertion (ASIC). mohor 8080d 16h /ethmac/trunk/rtl/verilog/
16 "else" was missing within the always block in file eth_wishbonedma.v. mohor 8087d 22h /ethmac/trunk/rtl/verilog/
15 A define FPGA added to select between Artisan RAM (for ASIC) and Block Ram (For Virtex).
Include files fixed to contain no path.
File names and module names changed ta have a eth_ prologue in the name.
File eth_timescale.v is used to define timescale
All pin names on the top module are changed to contain _I, _O or _OE at the end.
Bidirectional signal MDIO is changed to three signals (Mdc_O, Mdi_I, Mdo_O
and Mdo_OE. The bidirectional signal must be created on the top level. This
is done due to the ASIC tools.
mohor 8089d 16h /ethmac/trunk/rtl/verilog/

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2023 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.