OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] - Rev 40

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
20 minsoc_defines.v had a semicolon at the end of the two reset polarity definitions.

minsoc_top had a signal array for two different signals which was for backward compatibility. The compatible debugging module is so old that there is no reason for keeping it.

Documentation has been updated to better explain how to use the definitions files, minsoc_defines.v and or1200_defines.v. An example for Altera devices has been added too.		 rfajardo 5208d 17h /
19 Documentation update. How To: 7) Examples:
-Spartan 3E Starter Kit no Ethernet has been already tested and is known to work.
-Spartan 3E Starter Kit with Ethernet not yet.
-change of sw/support/orp.ld cannot be done by only commenting and uncommenting line, the instruction, documentation line, which said so has been removed.
-Further possibilities -> Further area optimization possibilities.		 rfajardo 5239d 21h /
18 Deprecated comments removed from the file listing files. rfajardo 5271d 22h /
17 Ethernet testbench speed penalty solved. Now Ethernet of testbench and minsoc can be enabled by only uncommenting `define ETHERNET on minsoc_defines.v.

send_mac, get_mac and uart_send tasks have been included/improved. Also a testbench, which works for both included firmwares is added. (eth and uart)

If ETHERNET is defined for the SoC, both firmwares will complete successfully. If not, the eth firmware will stall when trying to access the Ethernet module.		 rfajardo 5273d 17h /
16 Further initialization improvement of non-used signals, setting interrupt signals to 0 if module is not used. rfajardo 5278d 20h /
15 Including verified pinout for external spi flash on spartan3a dsp kit to its correspondent ucf constraint file. rfajardo 5279d 14h /
14 Wishbone error signal of Ethernet core was not tied to ground if Ethernet was disabled. Solved now. rfajardo 5287d 21h /
13 Updating spartan3e_starter_kit.ucf so that it does not deliver errors on mapping. Moreover it has been changed to off the shelf only have uart support. Ethernet support and generic JTAG can be added by uncommenting the corresponding lines. rfajardo 5288d 21h /
12 1) spi_top.v:
-TX_NEGEDGE bug reported and recommended solution by Blaise Gassend. (Thank you)
2) minsoc howto extended to:
-synthesis of minsoc for Spartan3E Starter Kit with Ethernet
3) spartan3e_starter_kit.ucf changed:
-it had problems regarding pin definitions and IO logic types for mapping and place&route. Working flawless now.		 rfajardo 5291d 13h /
11 External interrupt processing was being run multiple times because:
-external level interrupts have to be cleared
-internal interrupt status register has to be cleared
Since internal interrupt status register was being cleared before external level interrupts clearance, these internal interrupt status was being overwritten inbetween.

Solution:
-move status register reset to end of interrupt handler instead of beginning.

Testbench signal uart_srx initialized now.		 rfajardo 5298d 16h /

< Prev 1 2

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.