OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [trunk/] - Rev 16

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
16 Further initialization improvement of non-used signals, setting interrupt signals to 0 if module is not used. rfajardo 5501d 11h /minsoc/trunk/
15 Including verified pinout for external spi flash on spartan3a dsp kit to its correspondent ucf constraint file. rfajardo 5502d 05h /minsoc/trunk/
14 Wishbone error signal of Ethernet core was not tied to ground if Ethernet was disabled. Solved now. rfajardo 5510d 12h /minsoc/trunk/
13 Updating spartan3e_starter_kit.ucf so that it does not deliver errors on mapping. Moreover it has been changed to off the shelf only have uart support. Ethernet support and generic JTAG can be added by uncommenting the corresponding lines. rfajardo 5511d 12h /minsoc/trunk/
12 1) spi_top.v:
-TX_NEGEDGE bug reported and recommended solution by Blaise Gassend. (Thank you)
2) minsoc howto extended to:
-synthesis of minsoc for Spartan3E Starter Kit with Ethernet
3) spartan3e_starter_kit.ucf changed:
-it had problems regarding pin definitions and IO logic types for mapping and place&route. Working flawless now.
rfajardo 5514d 03h /minsoc/trunk/
11 External interrupt processing was being run multiple times because:
-external level interrupts have to be cleared
-internal interrupt status register has to be cleared
Since internal interrupt status register was being cleared before external level interrupts clearance, these internal interrupt status was being overwritten inbetween.

Solution:
-move status register reset to end of interrupt handler instead of beginning.

Testbench signal uart_srx initialized now.
rfajardo 5521d 07h /minsoc/trunk/
10 Added a file containing models for each FPGA memory instances used in or1200. The file is in bench/verilog/sim_lib/fpga_memory_primitives.v.

With it, people who change the or1200_defines.v inside of the project structure will still be able to simulate, using house-made models, not from manufacturers.

minsoc_bench.v had to be extended by the task, init_fpga_memory, to initialize the dual or two port memories instances of or1200. This has to be done based on the type of memory used, so many different instantiations based on definitions. Somehow or1200 expects all memory values to be 0 upon start, so this is necessary.
rfajardo 5535d 07h /minsoc/trunk/
9 Tiny change to testbench gain:
-uart_srx is now reg for future testbench serial input to SoC.
rfajardo 5537d 06h /minsoc/trunk/
8 Cosmetic changes to minsoc_bench.v:
-reset and clock initialization are included into the main initial block, it had an own block before
rfajardo 5537d 06h /minsoc/trunk/
7 Some changes:
-wb_cabs removed from minsoc_top.v and minsoc_tc_top.v
-added reset polarity control to minsoc_defines.v through:
-POSITIVE_RESET
-NEGATIVE_RESET
-minsoc_onchip_ram_top.v does not use
minsoc_onchip_ram.v oe signals (output enable) anymore,
which are implemented as tristate buffers. Now
minsoc_onchip_ram_top.v has a generated MUX, which
has an arbitrary number of inputs and 1 output.
Input are the internal output of the onchip_rams,
output the wb_dat_o.
rfajardo 5542d 06h /minsoc/trunk/
6 No implementation relevant changes.

Testbench used generic memory from minsoc_onchip_ram.v has been changed to reflect the correct model of the FPGA's onchip rams: address register and write accesses are sensitive to rising clock edge.

Documentation updated to reflect another trial and next steps to speed up the memory access from 2 clocks to 1. The negated clock approach is not standard. The right way to do it would be to use the wishbone signals cti and bte and change the minsoc_onchip_ram_top.v.
rfajardo 5546d 12h /minsoc/trunk/
5 vpi path corrected in how to. rfajardo 5552d 11h /minsoc/trunk/
4 minsoc_bench.v had a big memory declaration to load the firmware, which was not necessary.

jp-io-vpi.vpi has to be compiled for different systems so removed from the project. Documentation now explains how to do it.

Documentation now includes:
-vpi module compilation
-gdb patch for adv_jtag_bridge
-ideas for future work on minsoc (To Do v.2)
rfajardo 5552d 12h /minsoc/trunk/
3 Changed documentation
-advice to compile sw/utils before compiling target software
rfajardo 5556d 10h /minsoc/trunk/
2 First commit of project. Beta status:
-testbench: working
-firmware: working
-RTL: Working for: Xilinx Spartan-3A DSP Development Kit
rfajardo 5556d 10h /minsoc/trunk/
1 The project was created and the structure was created root 5556d 12h /minsoc/trunk/

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.