OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc/] [trunk/] [doc/] - Rev 22

Rev

Go to most recent revision

Filtering Options

Clear current filter

Rev Log message Author Age Path
22 Status progress and howto pdf documents were not commited, there now. rfajardo 5163d 13h /minsoc/trunk/doc/
21 Including the first draft project documentation. How to and status progress docs are now separate from documentation. rfajardo 5163d 14h /minsoc/trunk/doc/
20 minsoc_defines.v had a semicolon at the end of the two reset polarity definitions.

minsoc_top had a signal array for two different signals which was for backward compatibility. The compatible debugging module is so old that there is no reason for keeping it.

Documentation has been updated to better explain how to use the definitions files, minsoc_defines.v and or1200_defines.v. An example for Altera devices has been added too.
rfajardo 5170d 15h /minsoc/trunk/doc/
19 Documentation update. How To: 7) Examples:
-Spartan 3E Starter Kit no Ethernet has been already tested and is known to work.
-Spartan 3E Starter Kit with Ethernet not yet.
-change of sw/support/orp.ld cannot be done by only commenting and uncommenting line, the instruction, documentation line, which said so has been removed.
-Further possibilities -> Further area optimization possibilities.
rfajardo 5201d 19h /minsoc/trunk/doc/
17 Ethernet testbench speed penalty solved. Now Ethernet of testbench and minsoc can be enabled by only uncommenting `define ETHERNET on minsoc_defines.v.

send_mac, get_mac and uart_send tasks have been included/improved. Also a testbench, which works for both included firmwares is added. (eth and uart)

If ETHERNET is defined for the SoC, both firmwares will complete successfully. If not, the eth firmware will stall when trying to access the Ethernet module.
rfajardo 5235d 14h /minsoc/trunk/doc/
12 1) spi_top.v:
-TX_NEGEDGE bug reported and recommended solution by Blaise Gassend. (Thank you)
2) minsoc howto extended to:
-synthesis of minsoc for Spartan3E Starter Kit with Ethernet
3) spartan3e_starter_kit.ucf changed:
-it had problems regarding pin definitions and IO logic types for mapping and place&route. Working flawless now.
rfajardo 5253d 10h /minsoc/trunk/doc/
6 No implementation relevant changes.

Testbench used generic memory from minsoc_onchip_ram.v has been changed to reflect the correct model of the FPGA's onchip rams: address register and write accesses are sensitive to rising clock edge.

Documentation updated to reflect another trial and next steps to speed up the memory access from 2 clocks to 1. The negated clock approach is not standard. The right way to do it would be to use the wishbone signals cti and bte and change the minsoc_onchip_ram_top.v.
rfajardo 5285d 19h /minsoc/trunk/doc/
5 vpi path corrected in how to. rfajardo 5291d 18h /minsoc/trunk/doc/
4 minsoc_bench.v had a big memory declaration to load the firmware, which was not necessary.

jp-io-vpi.vpi has to be compiled for different systems so removed from the project. Documentation now explains how to do it.

Documentation now includes:
-vpi module compilation
-gdb patch for adv_jtag_bridge
-ideas for future work on minsoc (To Do v.2)
rfajardo 5291d 19h /minsoc/trunk/doc/
3 Changed documentation
-advice to compile sw/utils before compiling target software
rfajardo 5295d 17h /minsoc/trunk/doc/
2 First commit of project. Beta status:
-testbench: working
-firmware: working
-RTL: Working for: Xilinx Spartan-3A DSP Development Kit
rfajardo 5295d 17h /minsoc/trunk/doc/

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.