OpenCores
URL https://opencores.org/ocsvn/minsoc/minsoc/trunk

Subversion Repositories minsoc

[/] [minsoc] - Rev 152

Rev

Go to most recent revision | Details | Compare with Previous | Blame

Filtering Options

Clear current filter

Rev Log message Author Age Path
152 Roll back to retrieve minsoc from branches/rc-1.0. rfajardo 4734d 13h /minsoc
151 Creating tag release-1.0 from revision 150 of branches/rc-1.0. rfajardo 4734d 13h /minsoc
150 Updating installation script to retrieve minsoc from tags/release-1.0. rfajardo 4734d 13h /minsoc
149 Merging differences of release candidate 1.0 revision 140:148 with trunk. rfajardo 4734d 14h /minsoc
148 Renaming minsoc_wave.lxt to minsoc_wave.lxt2 for correctness. rfajardo 4739d 10h /minsoc
147 Updating minsoc_bench.v to correctly acquire uart data.

Uart drivers: when an end of line character was sent, the driver appended a carriage return to it. This is not necessary and has been removed.
-Eth and Uart firmwares also had a carriage return after the end of line, also removed.

Minsoc_bench_defines.v: Renaming VCD_OUTPUT define to WAVEFORM_OUTPUT

run_bench: selecting -lxt2 for waveform output format. This output format size is 10 times smaller than vcd.

minsoc-install.sh: lxt2 output format requires that Icarus Verilog be installed with zlib support. For that, we now check if zlib is supported on script run.
rfajardo 4739d 11h /minsoc
146 Importing 'Xilinx Microblaze Dev. Kit 1600E Edition' board configuration directory. ConX. 4739d 17h /minsoc
145 minsoc_bench_core.v and minsoc_bench_clock.v left only on verilator branche. It will develop there until it is ported for inclusion into trunk. RC-1.0 is now clean of it. rfajardo 4740d 02h /minsoc
144 Updating configure scripts. Calling make into the right directories now. rfajardo 4740d 13h /minsoc
143 Compiling firmwares in board configuration scripts instead of on global minsoc setup. rfajardo 4740d 13h /minsoc
142 Updating configure.sh:
1) we don't patch the trunk version.
2) it is better to re-compile the firmwares on reconfiguration. So compiling firmwares went to configure scripts instead.

backend/xxx/configure: compiling firmwares here now.
rfajardo 4740d 13h /minsoc
141 Merging with rc-1.0 revision 140. I doubt rc-1.0 will still change much in the last days. rfajardo 4740d 13h /minsoc
140 Including required modules for verilator simulation. rfajardo 4740d 14h /minsoc
139 Creating a verilator branche. rfajardo 4740d 14h /minsoc
138 DIR_TO_INSTALL creation using wizard ConX. 4741d 02h /minsoc
137 Removing uncomplete support for ml509 and not working support for spartan3e_starter_kit_eth (area constraint cannot be reached). rfajardo 4741d 13h /minsoc
136 Installation on Ubuntu-11.10 has shown that a binary called makeinfo is required to install GDB. This binary can be installed on Ubuntu by installing the package texinfo. rfajardo 4748d 09h /minsoc
135 Installation on Ubuntu-11.10 has shown that package texinfo is required to compiled GDB. This package installs the binary makeinfo. rfajardo 4748d 09h /minsoc
134 run_sim.bat for ModelSim updated to acquire the firmware_size for command line input when running the testbench. rfajardo 4755d 13h /minsoc
133 Roll back minsoc_bench.v to timed simulation. Merge minsoc_bench_core and minsoc_bench_clock again.

Applying Rubén Diez patch to avoid warnings on firmware load for simulation.
rfajardo 4755d 14h /minsoc

1 2 Next >

Show All

powered by: WebSVN 2.1.0

© copyright 1999-2024 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.