UART to Bus
uart_rx have some receive err bit #4
Closed andylgh opened this issue almost 13 years ago
andylgh commented almost 13 years ago
uart_rx have some receive err bit when i set baud rate 115200bps,and clk run 100Mhz.i test it in binary mode
motilito commented almost 13 years ago
Can you please elaborate? Did you try changing the number of stop bits of the UART to 1.5 or 2? Moti
motilito commented almost 13 years ago
UART was verified on an FPGA board with baud rate of 115200 and clock frequency of 48MHz. A problem was found when operated at high data rate and 1 stop bit. Transmit and receive module where corrected.
motilito closed this almost 13 years ago
© copyright 1999-2018 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.