Hello:

I am thinking of purchasing the Hollybush1 PC104+ FPGA board and use it
with a PC104+ based processor.

I plan to create a digital signal processing application on the FPGA using
verilog.

What I need is either decent information on PCI or at least enough verilog
code to create a PCI endpoint (not master, since I will have a processor)
that has DMA capability.

I have been a little frustrated in fining information on the PCI protocols
(it appears that most of that stuff is locked up in copyrighted docs).

Can any of you help point me to either decent PCI information, place to
get help writing a verilog implimentation of a PCI enpoint, or PCI code
either free or cheap (under $500)?

Thanks

Mark Allyn

Mark Allyn wrote:

So close, and yet so far... ;) There's an implementation on opencores that is exactly what you need. You can also grab the opencores DMA contoller to go with it. Regards, -- Mark McDougall, Engineer Virtual Logic Pty Ltd, http://www.vl.com.au> 21-25 King St, Rockdale, 2216 Ph: +612-9599-3255 Fax: +612-9599-3266