OpenCores
Home » All forums » Cores » decoding multiple output in picoblaze
no use no use 1/1 no use no use
decoding multiple output in picoblaze
by eng.sanchit on Nov 7, 2011 		eng.sanchit
Posts: 10
Joined: Oct 6, 2011
Last seen: Nov 4, 2012
always @(posedge clock) begin
if ( port_id == "00000001" ) begin
userbit1 end
end
assign LED = userbit1;
endmodule


this code was used to decode the port_id and match it , but it is not working properly , any idea ?
RE: decoding multiple output in picoblaze
by sergemoutou on Nov 15, 2011 		sergemoutou
Posts: 25
Joined: Jun 4, 2008
Last seen: Dec 12, 2025
I don't know verilog but a little picoBlaze.
Why you don't use the write_strobe signal ?
no use no use 1/1 no use no use
© copyright 1999-2026 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.