1/1 
|
Using ISim to simulate the Atlys board
by svenand on Mar 12, 2012 |
svenand
Posts: 31 Joined: May 12, 2009 Last seen: May 14, 2014 |
||
|
I am writing a blog on how to use ORPSoC. The latest blog entry is describing how to simulate the Atlys board using ISim.
http://www.rte.se/blog/blogg-modesty-corex/simulating-orpsoc-using-isim |
|||
|
RE: Using ISim to simulate the Atlys board
by olof on Mar 12, 2012 |
olof
Posts: 218 Joined: Feb 10, 2010 Last seen: Dec 17, 2018 |
||
|
This is good for all those who don't have access to modelsim. My main problem with ISIM is that it the crippled version that comes with webpack is incredibly slow and doesn't seem to support VPI, but for now it's the only cost-free way to simulate the closed-source memory controller.
You might want to check out my ISIM simulation support for ORPSoCv3 too that I wrote a few weeks ago if you are looking to automate the process. I actually used the Atlys board as a reference case. -- Olof Kindgren ______________________________________________ ORSoC Website: www.orsoc.se Email: olof.kindgren@orsoc.se ______________________________________________ FPGA, ASIC, DSP - embedded SoC design |
|||
|
RE: Using ISim to simulate the Atlys board
by svenand on Mar 13, 2012 |
svenand
Posts: 31 Joined: May 12, 2009 Last seen: May 14, 2014 |
||
|
I have fixed the bootup sequence by adding boot code in the rom.v file and preloaded the DDR2 memory. My simulation now runs successfully.
Sven Andersson Realtime Embedded Email: sven-ake.andersson@rte.se |
|||
1/1